开云体育

Hi Nate, There used to be a company called BetterRF in NM that had a Tune Control cable that worked like that. From the review site, it looks like they have been out of production for about 10 years.

I am using the acc-2 on my dx10 but I do not use an amp sent by ve3wej on samsung s21+ [email protected]> wrote:

Its now June 2024 I hope they figure it out soon for the at200 pro 2 and the ftdx10

Does anyone produce an interface cable for the LDG tuners and Yaesu FTDX10 that connect to the tuner port on the FTDX10 instead of to the Linear port? I need to use the Linear port for a PTT cable

The light in mine was so low I thought the leds were bad. I opened it up and added a led light panel on the inside. Works FB. I wrote about it on QRZ.

Others might find helpful..... I find that the meter's leds at maximum brightness are still a little too dim for my eyes. A very inexpensive alternative light (EWX book light) with 3 power levers, 3

Great!? Thanks for the info.? I have been manually switching to CW mode, setting my keyer to tune and then manually resetting back to the desired mode. This will be much more convenient.

I have an FTDX10 and an FT-710.? With the 710, you plug the ACC-1 cable into the ACC on the radio.? For the FTDX10, my understanding is you use the ACC-2 cable plugged into the linear port.? In

Doug - Thanks for the reply.? Unfortunately, I don't have a dummy load to test it.? However, with the tuner in bypass mode and using the radio's (FTDX3000) internal tuner on a known part of the band

Charlie - Thanks, I just checked the antenna with an SWR meter, and it's fine.? No change since the last time I checked it about four months ago. Regards - Bob KJ6GEU

With the Y-ACC 1 cable it will put the radio into transmit and tune when you press the tune button the tuner. Works great unless you need to use the FH-2 remote keypad. You cannot use both on the same

I have an AT-200ProII and Imhave noticed that there is a jack on the back for connecting a cable to a Yaesu rig. ?What do the tuner and rig do when connected together? ?Will it work with a Yaesu

You may have an ant relay going bad. I had to change out one on my old AT1000PRO once. It was a pretty easy repair and the relay was available from mouser.

Do you have a dummy load? If so, operate the tuner with the rig and amp at full power into the dummy load to see if the issue continues. If not, you are probably getting RF feedback into the tuner

did you check just the antenna with an SWR meter?My dipole is quite tasty to some squirrels.

Hi all - I'm new to this group. I purchased this tuner about 4-5 years ago and it's been working fine until recently. Twice in the past month, it lost its mind while tuning frequencies that have not

Hello Mike Thanks the reply. I've managed it by temporarily replacing my RT-600 with my new RT-100. Then in the shack I've removed the coax cables from the RC-600 and joined them with a barrel

According to the manuals for the RT100 and RT600 no dedicated controller is needed. A schematic for a suitable bias tee is in each manual. The only addition I can see is a way to interrupt the 12V

Thanks again Al I'll come up with a plan. All the best, Mick

More….. You can do your alternative test, but I’m not sure what you are testing in that case. Just run your go box into a dummy load with the rc-100 turned off. Al (again…)