开云体育

I figured it out and that cable will work. I posted it on the 710 IO group. Wyatt WA4VMF

Will the cable 108 work on the FT710 ? If so where would you plug the 3.5 mm plug to the radio? I have the Din plug into the turner connection on the radio. Wyatt

Hi Thomas. I’ve been using the FT-817ND from about 2008 until just this year when I got the Icom IC-705. I’ve done many tests on the FT-817ND. I have two. One has the Collins 2.3 kHz SSB filter

Thanks Michael for taking the time. Much appreciated. What you are saying makes a lot of sense but I wonder, how this equipment, which is designed to work with the Yaesu FT-818 runs into that SWR

Thomas my z-817 tuner will not go into PKT mode. I am sure I have it hooked correctly. But then agn I will checked. -- 73'S DE NU4N DAVE

FWIW, I have an original FT-817 (circa 2001) that I cannot easily use with an? ATU due to SWR foldback. What has happened to this rig is that at some point the SWR foldback operation became overly

Thanks Mike for taking the time to answer to my topic. I did not know about this weakness so thanks for bringing that up. I tried the relay F-R-F-R cycle and I clearly hear the relays working (no

Ken, the only hint I found is in the manual on page 11: "NOTE: Wait until the tuning cycle is complete before keying the radio or pushing the PTT button on the mic. Failure to do so will *leave the

Using the rear connector reduces your operating time by about 7%. In any case, that relay is known to develop dirty contacts and fail intermittently. You might try cycling the relay F-R-F-R to see if

Mike, I use the Rear PL-Socket. It is connected to the tuner with a 50cm Pigtail. And yes, the Antenna is set to Rear (= R in the Display)

Will do, Dave!

Which Antenna-Port on the FT-817 are you using? FRONT or REAR? Vy73 – Mike – KD5KC – WRFF851 – El Paso – Texas – DM61. The canyons are calling, colorful and deep. But I have promises to

I also have the same problem. Let me know if you all figure this out.

Dear Groupmembers, the issue below has been sent to LDG Support. However I trust that this comunity may have a hint too. Thanks for any hints. My setup: I use it with a Yaesu FT-818ND. A Pigtail ist

My AT1000 Pro IIbhad some weird things going on too, one of them was to turn the unit OFF, I had to hold the PWR switch in, as I did this, some relays would click away, then the unit would power down,

One is indicators for antenna selection. Mike N3PM

SV8YM has an article on an LDG AT-1000 that did not tune or acted weird. Here is a link to his blog that you might find interesting. April 26, 2014. http://sv8ym.blogspot.com/ Very interesting! JD

In the AT line, what is the difference between Pro tuners and ProII tuners? What did they change that prompted the change in model designation? Thank you. Bob...

Cheapham.com has the interface cable available: LDG (cheapham.com) ( https://www.cheapham.com/ldg-ic-2000-for-ft-2000-interface-cable-closeout/ )

Do you have first had experience with the mAT-Y200 or mAT-30 working with the FT-710?? I have a new FT-710 and several posts on that group indicate that it does NOT work with either of those