开云体育

Flex to amp cable

Rich McCabe #118 Trying to get my LA-1k connected to my Flex 6600.? I have the FTDI cable and then null serial cable from there. It runs my STEPPIR controller just fine but not the amp. When I change the mode in the menu it says "Cable Not Detected"
K1SRE Mark All Messages By This Member #119 Good Morning Rich: I believe that the LA-1K requires a PTT,?unless your FTDI interface has a relay to key the AMP it probably won't work. I have an ANAN 100D , there is a PTT ?port on the rear of the RIG . I use a MFJ optical relay to key the AMP. Maybe you can configure your USB interface to do the same ? ?73 Mark K1SRE toggle quoted message Show quoted text -----Original Message----- From: Rich McCabe Sent: Jan 15, 2019 6:27 PM To: [email protected] Subject: [la1k] Flex to amp cable Trying to get my LA-1k connected to my Flex 6600.? I have the FTDI cable and then null serial cable from there. It runs my STEPPIR controller just fine but not the amp. When I change the mode in the menu it says "Cable Not Detected"
[email protected] All Messages By This Member #120 Edited Make sure your cable from your amp is plugged directly in to TX 1 Jack. Then go to Radio settings and click TX settings. Select RCA TX 1 and click Enable. Under Max power type in the recommended wattage number of Manufacture not to overdrive the amp. If using ALC, click under Hardware Enabled. You will adjust the desired ALC level with the tune button engageged and the slider. Set the tune slider to 10 watts. Next to Mic then adjusted desired Mic Gain. Then you should be good to go. Julie
Bob Hinkle #1623 I can't seem to find instructions for creating a Flex to LA-1K amplifier.? Anyone have one and can send instructions to build one? ? Thanks... Bob KK8ZZ
Billy Parkinson All Messages By This Member #1624 You really don't need a cable, the LA-1K is RF sensing and will follow band changes.? Billy Parkinson KG5RQZ WRYA510 HH 11724 COR RACES 306
cturner craigturner.com #1625 开云体育 I agree.? The only cable you need is a PTT.? That is all I used. ? It's a good life, ? Craig Turner?W?LV ? ? ? ? ? ? ? toggle quoted message Show quoted text From: [email protected] <[email protected]> On Behalf Of Billy Parkinson via groups.io Sent: Sunday, January 26, 2025 8:17 AM To: [email protected] Subject: Re: [la1k] Flex to amp cable ? You really don't need a cable, the LA-1K is RF sensing and will follow band changes.? Billy Parkinson KG5RQZ WRYA510 HH 11724 COR RACES 306

Previous Topic Next Topic