开云体育

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Kicad-Users
  2. Topics

回复： [kicad-users] Linking between symbol and footprint ?

 

开云体育

I think the key problem here is physical and logical pin difference's check.
actually current flow donot control on any mismatch check between any symbol/footprint's creation process because both always front&back end group team design activity.
so the problem will finally catched until when user using symbol in schematic and sync to PCB with the wrong footprint..

we should make? this kinds of check during the flow of footprint assignment tool instead of the function of "Update PCB from Schematic"
?
?


------------------?原始邮件?------------------
发件人: "Andrew Armstrong"<andrew@...>;
发送时间: 2022年12月29日(星期四) 晚上7:09
收件人: "kicad-users"<[email protected]>;
主题: Re: [kicad-users] Linking between symbol and footprint ?

There is a tool called "highlight wires and pins of a net" in the
schematic editor just below the arrow tool at the top of the right hand
toolbar. This highlights the trace and pins on the PCB window, if it is
open (prefera bly on another screen)

Andrew


On 28/12/2022 04:46, David Slipper wrote:
> When in the pcb editor you can click on a trace and have it
> highlighted on the schematic editor.
>
> Is there a way of doing something similar between the symbol editor
> and the footprint editor.
>
> Alternatively is there a way to detect any pins that don't tie up
> between them ??
>
> I have a rather large device to enter as a symbol and footprint and
> checking it will take ages.
>
> Any advice is very welcome
> Dave
>
>
>
>
>
>
>
--
e: andrew@...
m: +44 (0)7802 740593
t: +44 (0)1525 376339

1 - 1 of 1