开云体育

HelloWhere can I find one or more component libraries for Kicad in which I will have 3D resistors with value rings? And also a 555 circuit with the manufacturer's reference and logo? Thanks for your

Hi 1. You need place text on PCB first (silkscreen, for example) 2. You need to use appropriate 3D models for components (555 marking, resistor coding rings) 3. You need route traces on PCB to have

HelloThis time it works. What is the method to write text on the 3D PCB? On the 555 IC? How to add colored circles to resistors? I also still have to trace the tracks But that should not be a problem.

Hello. Try the attached footprint. Place it into a folder created by you and configure the relative directory in kicad. Angelo <kiwiantipodean@...> ha scritto:

The problem is that the connector has an edge cut on either the footprint or the step file. The result is that the PCB below the connector becomes a cutout. This is covered in "Kicad Like a Pro for

If you expect the shape of your PCB different, make sure your edge cuts is a fully closed polygon wrote:

Hello,I can't find what the problem ?isPart of the PCB is missing Thanks for your helpStanislas

I am using KiCad 6.? I can't drag diff pairs as a pair.? Have seen this done in a YouTube video by Tom W.? Also effects length tuning; meanders will not form if there's no room.

here is the step file Stanislas

Hello, My son is drawing the Step file while I'm writing to you. I'll send it to you as soon as it'll be finished. ?On the other hand, I'd really appreciate if you draw the footprint. I'll take care

Ok, it could be sufficient. Angelo stanislas.thouret@...> ha scritto:

Hi John, I agree the selection system in KiCAD6 is a bit long-winded. Everyone has their preference, and usually the one they got used to with a previous package. My 'previous package' was

joint connector drawing Stanislas

Ah thank you If it suits you I can send you a drawing of the connector in .dxf format that I will make from the connectors. Stanislas

Hello. I can provide the 3D model , for you and all other users, if you send me the datasheet of the connectors where I can collect the dimensions of various parts. Angelo stanislas.thouret@...>

Many thanks for the explanations and the modified diagram Stanislas

HelloTo use it in a Kicad PCB I am looking for a + 3D footprint of this 1 x 3 V with a pitch of 2.54 mm male female connector Thanks for your help

They have radically changed how editing occurs in that items must be "in scope" in order to edit them. You can edit front silkscreen items by first clicking on the f.silkscreen layer to make it "in

You have a few small errors: You need to place No Connection flags to pins 4, 5, and 7 to tell KiCad you intended for those pins to be left unconnected. You need to move some wires (from J3 and to pin

Ah thank you I'm saved :-) Stanislas