开云体育

Hi. I was looking for a way to expand the Kicad libs adn I found this text about converting Orcad to eeschema. This seens to be a little old but it really can convert all Orcad libs to be used on

Hi, Mr. Charras Please, is it possible to use A4-Portrait Format? Id like to set up the page to Size A4 - Portrait but I dint find it (Page Settiens Window). Then, I set up the Size User (X:

Adilson Oliveira wrote: this is probably not the place to discuss it but IME I have only come across spaces in file or path names under Linux when running Windows programmes under Wine. Ian -- Ian

Tonamiben wrote: The group is less than two months old so there is as yet no group policy., However, as a start I recommend we adopt the standard netiquette guidelines in Section 3 of RFC 1855 which

<ftp://iut-tice.ujf-grenoble.fr/cao/> Is there a group policy or some documents on the good practices on a newsgroup? Thank you

Royce Pereira wrote: Are you running Kicad under Windows or Linux? I know spaces in file names are common in Windows but it is not permmitted under Linux. Ian -- Ian T-Bell aka RuffRecords aka

Hello, I have come across the exact same problem. This is not an issue just for high frequency behaviour of the circuit but also with the etching. This staircase step in direction of the 45 degree

Edouard Greiffiths wrote: If you look at the ftp site link which is the first one under the Download section on the LHS of the site it will take you to a page with all the kicad files including the

Edouard Greiffiths escreveu: Hi again. They are under the ftp repository IIRC. The links for them are on the project page, no mistery at all ;) []s Adilson.

Ian bell escreveu: Hi. Just one note: I don't know in the case of Kicad specificaly but file names with spaces are perfectly normal in linux. []s Adilson.

Hi, I'm using Windows XP SP1 Thanks, --Royce.

Edouard Greiffiths wrote: This is a very good idea to fine-tune the copper pouring, at least the gerber output, this should be very nice. Benoit

OK Juan, cool! indeed, I missed the topmost links on the full FTP directories and jumped into the "separate files" expecting them to be there. This closes the subject. Thank you all,

Hi Edouard, You can find the sources here: ftp://iut-tice.ujf-grenoble.fr/cao/sources/ Regards, Juan

check the ftp sites. the links are on the web site. Edouard Greiffiths wrote: that would be nice. I've been meaning to start playing with the code as well, just too busy... -ryan

Hi Adilson and the list, well, I did look at the website (http://www.lis.inpg.fr/realise_au_lis/kicad/) with scrutiny and still didn't find it. I was a bit upset hence the tone of my message. I would

Hi, Is there an automatic procedure to create/update equ files? I did not find anything in the Help. Thanks, --Royce.

Hi, However, Better, Kicad should throw an error if it finds disagreeable characters in the names etc., or automatically insert underscores, rather than allow an hours work to go down the drain

Edouard Greiffiths escreveu: Well, the sources *are* avaliable :) I compiled it here to give support to hardware 3D. I think you just didn't look hard enough ;) []s Adilson.

How comes this software pretends to be open source when the sources are not available?