开云体育

  1. Jmriusers
  2. Topics

JMRI and LogicX driving Signals #signals

 

Wanting to drive a Signal based on a decision 'to set green / red' from a LogicX - already set a sensor 'light' on the screen and switch turnouts,, looking for guidance to then set a dwarf signal.
?
unable to use turnout motor switches as there are two x three-way turnouts used.
?
If there is a write up or Youtube I would appreciate in pointer, all i have seen so far are track sensor based and switched from a single turnout motor.
?
Happy to answer any questions...
?
thanks
Randall
 

开云体育

Randall,

?

What system is your layout? Like what system are you using for the turnouts? Driving a signal lamp is really the same as driving a turnout motor. At least to JMRI. Look at ‘Signal Heads’, most of those outputs are using a turnout entry to drive the lamps.

?

-Ken Cameron, Member JMRI Dev Team

?

?

1 - 2 of 2