Help With crossover
|
Hi Members
Could someone please help me out with A Single crossover and JMRi
?
First things first.
Please take a look at this photo of the Crossover
I presumed that one turnout has one Block so A Crossover just needs 2.
Is that correct?
Each end of the 4 crossover ends i have isolated,Power is feed to the small joins attached to the(each side) crossover(2) to make 2 blocks with sensors
Is that correct?
?
My problem comes when i choose single LH Crossover in JMRI then when i go to set masts it ask for 4 Blocks,but i only have 2
Can someone explain the Four please?
?
Appreciate your time
regards Brett
?
PS.DCC Kato Crossover.
|
|
Brett, Your configuration looks correct. While it is possible to specify up to four blocks, the normal process is to use one block for the first two entries and one for the other two entries. Sometimes, for historical reasons it is not possible to treat the crossover as having only two blocks. Dave Sand ----- Original message ----- From: "redsash63 via groups.io" <redsash63=[email protected]> Subject: [jmriusers] Help With crossover Date: Thursday, April 10, 2025 4:12 AM Hi Members Could someone please help me out with A Single crossover and JMRi ? First things first. Please take a look at this photo of the Crossover I presumed that one turnout has one Block so A Crossover just needs 2. Is that correct? Each end of the 4 crossover ends i have isolated,Power is feed to the small joins attached to the(each side) crossover(2) to make 2 blocks with sensors Is that correct? ? My problem comes when i choose single LH Crossover in JMRI then when i go to set masts it ask for 4 Blocks,but i only have 2 Can someone explain the Four please? ? Appreciate your time regards Brett ? PS.DCC Kato Crossover. |