¿ªÔÆÌåÓý

  1. Jmriusers
  2. Topics

Locked Determine Digitrax UR92 firmware with JMRI and Locobuffer USB

 

Can I determine the UR-92 firmware level in the device with JMRI and a Locobuffer USB interface. I see where I can upgrade the firmware but not read the current level.

Thanks in advance for any input.

Jack Varadi
 

If you use the DigiIPL v2.2 software provided by Digitrax it will tell you the firmware version and the RF version of your UR92 (remember there are two updates you may have to do). Go to the Digitrax website and look under the downloads link. I have provided a detailed explanation of how to do this at? . This is the Hostlers web site of Ogden Utah. It discusses both the DT402 series and the UR92 firmware and RF upgrades with the LocoBuffer-USB which is what I use.


On Thu, Sep 5, 2019 at 3:02 PM jackvaradi via Groups.Io <jackvaradi=[email protected]> wrote:
Can I determine the UR-92 firmware level in the device with JMRI and a Locobuffer USB interface. I see where I can upgrade the firmware but not read the current level.

Thanks in advance for any input.

Jack Varadi



--
John Griffin? ? ? ? ? ? ? ? ?
_______________________________
If today was your last day...
 

Hi John,

Thanks for the link. I gather that by selecting the right COM port and baud rate for the Locobuffer I can use the Digitrax S/W to determine rev. levels in the UR-92 without the need of a PR3. Also gather I cannot do this with JMRI.?

Thanks,
Jack Varadi
 

Yes, I have always used my Locobuffer with the Digitrax software

Tom in Texas
 

Ken,

The DigiIPLII software is a windows exe file that runs independent of JMRI. Basically plug your locobuffer-usb into your command station, plug the UR92 into the command station, run the software on your computer and you're off and running. It would be better to read the documentation I gave you the link to so you understand the finer points of the upgrade. Otherwise, it may cause problems.

On Thu, Sep 5, 2019 at 3:36 PM jackvaradi via Groups.Io <jackvaradi=[email protected]> wrote:
Hi John,

Thanks for the link. I gather that by selecting the right COM port and baud rate for the Locobuffer I can use the Digitrax S/W to determine rev. levels in the UR-92 without the need of a PR3. Also gather I cannot do this with JMRI.?

Thanks,
Jack Varadi



--
John Griffin? ? ? ? ? ? ? ? ?
_______________________________
If today was your last day...
 

All,

Thank you for the replies. I have successfully update my UR-92 using the Digitrax S/W and Locobuffer. I believe the correct baud rate is 57600 (the only option some of the Digitrax programs allow).

Jack Varadi

1 - 6 of 6