¿ªÔÆÌåÓý

  1. Jmriusers
  2. Topics

Locked RH crossover issue with signals

 

I am having problems setting up a RH crossover for signals. I have three LH crossovers which were set up without difficulty. When I right click on the RH crossover on the Layout Editor of JMRI and select set up signals it gives the typical options for the signals at the A,B,C and D locations. ?However the options don¡¯t correlate with the turnout. ?If I'm not mistaken, there should be two options for A (continuing and diverging), one for B, two for C and one for D. ?However there is only one for A and D and two for B and C. ?Any ideas?
Bob
 

Bob,

Are you using signal heads or signal masts?

Dave Sand

On Sep 2, 2019, at 8:23 PM, Robert Perry via Groups.Io <rjpod@...> wrote:

I am having problems setting up a RH crossover for signals. I have three LH crossovers which were set up without difficulty. When I right click on the RH crossover on the Layout Editor of JMRI and select set up signals it gives the typical options for the signals at the A,B,C and D locations. However the options don¡¯t correlate with the turnout. If I'm not mistaken, there should be two options for A (continuing and diverging), one for B, two for C and one for D. However there is only one for A and D and two for B and C. Any ideas?
Bob
 

Right now signal heads. I was able to get it working. For some reason JMRI is not letting me set up signals for a RH crossover in the same session as a LH crossover. If I save the panel and restart JMRI I can then configure the crossover. To go back to a different type of crossover, I again have to save and then restart. Weird but it is working.?
 

Bob,

I have submitted a fix which will create a new panel when the different type of cross-over is selected. It is PR #7387.

Dave Sand

On Sep 3, 2019, at 11:32 AM, Robert Perry via Groups.Io <rjpod@...> wrote:

Right now signal heads. I was able to get it working. For some reason JMRI is not letting me set up signals for a RH crossover in the same session as a LH crossover. If I save the panel and restart JMRI I can then configure the crossover. To go back to a different type of crossover, I again have to save and then restart. Weird but it is working.

1 - 4 of 4