开云体育

A possible bug in the Sountraxx DSD150 Diesel programmer's Function Mapping
screen. I wasn't able to confirm this on any other programmers -- I was
especially hoping someone could check a DSD150 Steam Function Mapping screen
since it's guts are probably similar. Here's what happens:

When using the Function Mapping screen for the first time, all check boxes
show up and can be manipulated. However, after performing the Read Sheet
operation, the boxes reflect decoder programming as they should, but any
time you return to that screen, there are no check boxes in any of the
columns to the right of and including F1 and the column headers "bell",
"horn", etc. are replaced by numbers. The boxes are lost forever for this
particular roster entry. Any new virgin screen contains all the boxes like
it should. Seems to happen only after a Read Sheet operation.

Also, is this the proper place to report bugs or is there a special address
to use?

Aloha,
Jim

At 12:30 PM -1000 9/8/02, Jim Buckley wrote:

A possible bug in the Sountraxx DSD150 Diesel programmer's Function Mapping
screen. I wasn't able to confirm this on any other programmers -- I was
especially hoping someone could check a DSD150 Steam Function Mapping screen
since it's guts are probably similar. Here's what happens:

When using the Function Mapping screen for the first time, all check boxes
show up and can be manipulated. However, after performing the Read Sheet
operation, the boxes reflect decoder programming as they should, but any
time you return to that screen, there are no check boxes in any of the
columns to the right of and including F1 and the column headers "bell",
"horn", etc. are replaced by numbers. The boxes are lost forever for this
particular roster entry. Any new virgin screen contains all the boxes like
it should. Seems to happen only after a Read Sheet operation.

Also, is this the proper place to report bugs or is there a special address
to use?

Sorry for the slow response. I was hoping that somebody else with a DSD150 could try that and see if they get the same thing.

This is a fine place to ask about problems, etc.

Which version of the program are you using, and which DCC system?

Bob
--
--------------
Bob Jacobsen (Bob_Jacobsen@..., 510-486-7355, fax 510-495-2957)

Which version of the program are you using, and which DCC system?

I'm using v1.0.6 (I check frequently for updates) and a Digitrax system.

Aloha,
Jim