开云体育

You are right! Pressing 'zoom/no zoom' - even if the bullet was already at 'no zoom' - makes the icons start flash as they should. Thanks! Torgrim

Hi, I am fairly new to model railroading, but a long time software developer, primarily c, c++. I have been developing a set of arduino style hardware interfaces for model RR control:

@ Dave Thanks for the info. I will update. -- Steve 009 in UK

@ Steve G. Brilliant Thanks. So If I understand correctly... * Stop "allocating allocation" sensors? whilst this sensor is active. It is not the sensor allocated to the train's stopping position *

I just tried sending using the Send NCE command tool and it works for all tracks except 00 for home.

That was my guess, but I don't know how to generate a turnout command with zero as the address in a script.?AD 00 00 04 00

Anthony, For those JMRI versions which do not have an "Ops Mode Programmer", use the "Address" mode to access "Ops Mode" programming. You will need to specify the address of the Tower Controller Mk II

All good. Given train tracking is done via the Control rather than Layout Panel I'd expect it to be related to occupancy blocks and I got rid of all the error messages reported when I edited those,

Thanks for checking that and letting Steve and I know. This will be in the 4.17.1 test release when it comes out, probably in a couple weeks. Unfortunately, it came too late for the 4.15.9 that just

Steve/Bob I've just tried Dev build #3344 and everything looks good: * Web browser and native panel images change in sync during normal movements * When block value is unrecognised, the defaulticon is

Chris, For the Layout Editor panel, use the Tools >> Check items to make sure there are no block continuity gaps. It is very easy to miss the block assignment for the track segment between two

I've tested it without the physical layout connected using the sensor table to manually change sensors between active and inactive simulating a train traversing the tracks and get the same problem. In

My first try at LOGIX...I'm trying to set up a LOGIX to check a sensor for being Inactive for x seconds and then set it to Unknown.? I see how to check the sensor, but I don't see how to set it to

Hi, I have just completed the first stage of a layout and would really appreciate some basic help in using JMRI version 4.12 via Windows 10 to set up the RR CirKits Tower Controller MK II. Perhaps the

I've noticed that custom animated GIFs I've made in the past only seem to work if the Layout Editor zoom level is set to 100%.? If I set mine to any other zoom level, I get the erratic operation

Marc, Does your answer imply that the tabs give access to separate Tables - one for each type? This would explain why the Internal Table is filled but the other is empty. Sent from my iPhone - Dave

Bill, If I remember right with the ACM setting to track zero sets the home position. (then wait sufficient time) Dick :)

I'd like to second what Ken suggested about using JMRI as your basic start-up mechanism.? Besides the computer's ability to start-up JMRI automatically, and to run a script at start-up which turns on

Never mind. It all works. The tip to change turnouts from IT to LT, was golden. Even WiThrottle to control train by cell phone (an iPhone in this case), works great, unrelated to my original problem.

In the turnout table you should see, at top, a tab for? INTERNAL? and a tab for? LOCONET. If you do not see LOCONET then your CONNECTIONs is not setup proper in Preferences. If your Preferences are