开云体育

Hi. Yes the PDF printed fine so I guess it is a printer issue. I just wonder why the results would be different? Interesting. I cannot find any setting on the printer to ?do something that can

Mark asked: "Has anyone used the Configure Command Station tool on a DCS240 and discovered it did not work ?" While I have used the tool with a DCS240 on a number of occasions, it has worked without

Cliff wrote: "What can be clearly observed is that the status reports for some OpSw values cannot be depended upon to be correctly reported. From here, my only record of the questionable status is

Thanks, Breezly I will look into this today and let you know how I made out. However, the program is moving both cars, from staging to staging or to a yard. It's just not giving me the two moves at

Don OK good to know. Today (Sunday) my layout was on a Layout Tour with 11 other layouts. 10.00 am to 4.00 pm - now it is over. I had a problem with my phone - unable to drive a train, it showed on

Mark, The Purge time setting was an attempt to sidestep what we now believe to be a repair problem with the DCS200 on our workbench. We now know that some conversation with the Digitrax repair

okay so.. When I do the delete paths routine, save, reload, and generate signal pairs.. the S01 to S08 path works, SML shows the blocks used etc. I save the file, close JMRI, re-load and then check,

That worked a treat! Thank you! The issue with crashing trying to change the section stopping sensor is still persistant, though. -- Thanks Mitch

Paul, Set the build report option to "Very Detailed" (Info available here: https://www.jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#BuildReportDetails ). Then build the train.

Mitch, I was able to get the SML from S01 to S08 to work. If you have been making a lot of block changes, the block routing can get confused. The unique double crossover at LT2-3-4-5 and its blocks

Haha no worries! Let me kow what you find, im still siving through things. -- Thanks Mitch

Mitch, Don’t worry about BR-2003-WE. The internal name for BR-2003 turns out to be BR-2003-WE. Dave Sand

dave, That should be uploaded now. I'm struggling to find the BR2003-WE signal definition. The folder of definitions just shows BR2003 but when i go to add a signal, im only shown BR2003-WE. I have

Mitch, You can upload the session.log file. It is at the settings location/logs. See Help >> Locations. Dave Sand

Dave, The auto-generate does work, however S01 should not be able to get to S04, and S01 cant get to S08, but can get to S07, the error being jmri.JmriException: Path not valid, prtecting block is

Mitch, I see that you have a custom signal system: BR-2003-WE. You will also need to create a zip file and upload that to your problems folder. Dave Sand

Mitch, I loaded your panel, deleted all of the signal mast logic and did the automatic generate successfully. The screenshot is curious but does not show the environment. If you have the JMRI console

Hi Dave, I have uploaded my XML file, shorty followed by a screenshot of error messages. -- Thanks Mitch

Mitch, Screen shots are uploaded to the group’s Photo area. If you upload your panel xml file to the Files ProblemsBeingWorkedOn Folder, we can see if there is a data issue. Dave Sand

The plot thickens! The Discover Signal mast does not seem to work anymore, and if I have the message log open, it throws an error and crashes. Same error as above. I have a feeling that my file is