开云体育

Thanks Dave. I had never used the JMRI Console so had to study documentation to even find it. It showed that the roster entry file I want to copy could not be found. This surprises me because the

Fraser, Try this xml file: /g/jmriusers/files/ProblemsBeingWorkedOn/dsand/37%20Heaven%20DS.xml This file has a LRoute and Routes to initialize the sensors and turnouts during startup.

The printed report and the export to CSV are totally inadequate.? They don't show any of the selectable options for the trains such as load, car types, etc.

I hope this is now fixed. If you’d like to check, there are installers are http://builds.jmri.org/jenkins/job/Development/job/Packages/ Bob

Hi Dave Thanks for your response. I have downloaded and installed 4.15.6 and have followed your instructions. Unfortunately I still seem to be having the same problem of all the signals along a route

Hello, I am new to this group and JMRI and have come across the following issue: On Ubuntu 18.04/ JMRI 4.14 CV 349 (function key braking rate) does not appear in the CVs pane (or any other pane) for

Rizimine, In looking at your picture of the wiring at the bottom and comparing it with the one of the yellow wire connected for programming, I think your problem is you are connecting the yellow wire

Leo, You can turn on Function Refresh in setup command station. Other possibilities are incorrect Function Map settings, or loco set to 14 step mode (CV29). Dave in Australia

Dave S. Interestingly, using the Turnout Control Tool actually adds entries to the turnout table as you address each turnout, so that's a bonus. It will if the JMRI SPROG configuration is set for

Jan, I tested both duplicate using the edit menu and duplicate using the right click context menu. They both created a duplicate entry. Check the JMRI console log for any possible error messages. Dave

Hi John - I had to put this on hold for a bit - hope to get back to it sometime late June.

JMRI 4.14 on Mac OS Mojave 10.14.5 java 8.211 I cannot duplicate a roster entry. Select an existing entry on the roster which becomes highlighted then select "duplicate" from the "edit" menu opens a

Soldering in the pictures looks fine. I’ve a couple of suggestions: a) When “programming” the decoder, with the yellow wire: Are you just touching this to the rail, or are you pushing it down

Thanks for all the helpful posts guys. I will try to respond to the most important queries since the last time: 1. @Dave Heap - The SPROG is in Command Station mode. I was not checking this earlier

Are these lights being driven with a NCE "Light-It? I assume we are now speaking of any lights on the loco? A light-it can be driven by a Loco address or an accessory address. I believe an accessory

Fraser, Try resetting the NX and SML definitions. Delete all of the entries in the NX table. Delete all of the entries in the Signal Mast Logic table. Save the panel xml file, stop and re-start

Also do not forget that NCE does not refresh, which means if there is even a slight interruption (dirty track, dirty wheels, pick-up issues in general), you will loose the light. It will come back if

Hi! I do have a Spog Pi also. This is on my Z Scale layout. JMRI runs that same as on Windows & Mac. The Pi has an operating system on it, Raspian Stretch. If you have a monitor, keyboard & mouse

Barry, We need to know the brand and model of the decoder.? There are some decoders that have different states depending on whether or not the locomotive is or is not moving. Steve Lowens

Hi I am a new user so please bear with me. Operating Equipment: Mac OS 10.13.6, NCE USB interface, NCE Power Cab Version 1.65, Engine Driver App on an android phone. I have several problems but I have