At 9:31 PM +0000 8/10/02, original_black_bart wrote:
To Jon and other testing CVP's AD4 DecoderPro file,
I managed to get a little time this afternoon to modify the screen
format for the AD4. I've run into a little bug and wondered if
someone would be kind enough to program their AD4 to an address
greater than 63, then read the data back and confirm the write.
Based on what I've seen while testing this out this afternoon, any
address greater than 63 is not written properly to the decoder. I
don't think CV9 is being set correctly but I can't tell for sure as
I'm working with a PR-1 to read back my data. Your confirmation of
such would be appreciated.
There may well be a bug there, as that's the new code that I wrote without a way to test directly.
There are a couple of things that might help figure out what it's doing wrong. The "Simple Programmer" from the tools menu will let you read back the value from CV9 to see what it was sent to. Using the "Comprehensive" programmer format will give you a CV pane where you can see the intended contents (although you might not want to trust it, as the bug could have effected that too).
And adding the line:
log4j.category.jmri.jmrit.symbolicprog=DEBUG
to the default.lcf file will generate trace information from the programming operations. (You might want to send that to a file; there are instructions at the top of the file for how to do that)
Sorry for the trouble.
Bob
--
--------------
Bob Jacobsen (Bob_Jacobsen@..., 510-486-7355, fax 510-495-2957)
At CERN until August 10, replies may be slow.
Bob Jacobsen