开云体育Just a few commentsIf you have 3. 4x8 board layout and only 4 blocks your not going to have many trains running. ?Your blocks should be train length. ?On my 8x8 layout i have over 40 blocks. I use digitrax and rrckts interface also. Each block must be connected to the loconet via a bxp88 (8 blocks per device with transponding) or bdl168 (16 blocks per card-no transponding) board. ?Your switches get connected to the loconet via ds64 devices. I believe you can use virtual switches and not actually have your switches connected to the internet. Reporters work off of transponders. Your decoder in your engine must have transponding. Many new one do, old ones dont. Reporters are added to your layout panel and tells you which engine is in which block. You must have a signal system setup on your layout panel. Again the signals dont have to be real on the layout. Trains travel from block to block via your layout panel which tells the computer how your blocks are connected. It reads signals at the junction of each block. The computer then runs your trains after you set up routes, transits, and trains. Are you doing operations? What do you want to do. Tony On Aug 21, 2018, at 3:24 PM, george.pendergraft <gmpender@...> wrote:
|
