开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育

Ic-7000 cuts off until warmed up


 

Hello All.

Problem with IC-7000. After about a 20 minute warm-up no problem.

I acquired an IC-7000 from a silent key. Maybe it was used once. Perfect except when I first turn it on it comes up fine. Then when I tune it to a different frequency, I lose reception. Audio still working. No transmission. The I turn it off and back on, all is good. I added a new power cord with fuses. I removed the from panel and inspected inside all tight. The rig was sitting on a shelf for about 8 years and not used. So, is it burning in? Transmits full power on all bands. Thanks to anyone that might have any ideas.

73
Frank
WA3RSL?


 

I'd sell it with an AT-7000 for $650.00. The problem is very intermittent. I've been having QSO's with it. It is super clean!

73
Frank
WA3RSL


 

开云体育

What is a AT7000??


From: [email protected] <[email protected]> on behalf of WA3RSL <fdew22@...>
Sent: Friday, November 10, 2023 5:43:07 PM
To: [email protected] <[email protected]>
Subject: Re: [ic7000] Ic-7000 cuts off until warmed up
?
I'd sell it with an AT-7000 for $650.00. The problem is very intermittent. I've been having QSO's with it. It is super clean!

73
Frank
WA3RSL


 

The matching? auto tuner.?


On Fri, Nov 10, 2023, 17:18 W1JCW <w1jcw@...> wrote:
What is a AT7000??


From: [email protected] <[email protected]> on behalf of WA3RSL <fdew22@...>
Sent: Friday, November 10, 2023 5:43:07 PM
To: [email protected] <[email protected]>
Subject: Re: [ic7000] Ic-7000 cuts off until warmed up
?
I'd sell it with an AT-7000 for $650.00. The problem is very intermittent. I've been having QSO's with it. It is super clean!

73
Frank
WA3RSL


 

The AT-7000 was LDG's antenna tuner that was made to complement the IC-7000 as an alternative to Icom's AT-180.

-Brian, KB3ORR


 

Where are you located?


On Fri, Nov 10, 2023 at 18:43, WA3RSL
<fdew22@...> wrote:
I'd sell it with an AT-7000 for $650.00. The problem is very intermittent. I've been having QSO's with it. It is super clean!

73
Frank
WA3RSL


 

You are a problem in main unit with reset signal; this signal goes in error mode and it blocks DDS UNIT. So you loose RX and no TX. When you turn off and then on the radio, suddenly works but when you use DIAL, CPU goes a bad signal in RESET mode. You have to check main unit with 3 chips closer each other. You have to follow RESET line from LOGIC BOARD to MAIN UNIT. The issue is on MAIN UNIT reset line.
73s Pasquale IW0HEX

Il giovedì 9 novembre 2023 alle ore 01:36:32 CET, WA3RSL <fdew22@...> ha scritto:


Hello All.

Problem with IC-7000. After about a 20 minute warm-up no problem.

I acquired an IC-7000 from a silent key. Maybe it was used once. Perfect except when I first turn it on it comes up fine. Then when I tune it to a different frequency, I lose reception. Audio still working. No transmission. The I turn it off and back on, all is good. I added a new power cord with fuses. I removed the from panel and inspected inside all tight. The rig was sitting on a shelf for about 8 years and not used. So, is it burning in? Transmits full power on all bands. Thanks to anyone that might have any ideas.

73
Frank
WA3RSL?