开云体育

I tried the demo out yesterday on a fast win10 x64 machine. It was a bit slow in responsiveness. Selecting and moving items was not intuitive, but I admit I didn't read the manual either. Drawing

Ban time, methinks!

If these were parts that you made, I can see a number of possibilities.? If they were not, then the main thing may be that the parts were not positioned on the grid properly.? EAGLE will not connect

yea.....??? " Things ought to connect at that point." and thats my dilemma. I asked on forums and got tons of advice but still coul dnot get the desired result with EAGLE so I declared defeat

What that *sounds* like is that you did not connect to the part properly. Eagle has a problem with parts that don't have schematic pins on a 0.1 inch grid.? Been there, done that.? Remade the

Hi Rob, I'd be interested in what you think of PCBCAD51 after you take a look at it. Steve

My needs for electronic circuit design are CAVEMAN simple. So I was pretty stunned by EAGLE when I went through the motions of picking parts out of the libraries and then drawing the "net" connections

I've used EAGLE for years, but that's version 7.7 for which I have a hobbiest/non-profit license.? It takes a bit of getting used to, and has a quirk or two.? My problem with Kicad is that it has no

I spent an extremely UNrewarding 3 months learning EAGLE and KiCAD and got tripped up by some glitches. If PCBCAD51 proves to me to be without those glitches then I would buy it.

Gentlemen, gentlemen, please tone it down. Here is the policy about ads from this group's monthly mailing: "Suggestions, recommendations and such, to and from professionals and companies are welcome.

[quote] It's advertising of his CAD software. The same poster has been flooding diyAudio threads with repetitive information and posts that don't add value to a thread.. [/Quote] -- I have wrote some

It's advertising of his CAD software. The same poster has been flooding diyAudio threads with repetitive information and posts that don't add value to a thread. His vague post above and the

abcfab on eBay.

If you're up to that kind of thing, I'd suggest an FPGA with a fairly big internal memory and dedicated capture.? SPI interface to registers would work well.? That way, you're not limited to the

Just sharing my project. My fastest scope so far is 23 MS/s and just a single channel. I use Analogue Devices AD9283 which comes in versions up to 100MS/s. The weakest link in the chain is the

Try to degine the same paper as if.edium heavy likt 110gsm. The the heater temperature would increase. [email protected]> wrote:

Hey Thanks All! All of your replies have suggested plausible work-arounds! The WinXP virtual mode is a slick one, and very likely will resolve the problem. The reason I consider this, is due to the

Received from Frank, G0GSR at 9/24/2019 18:50 UTC: Most laser printers - especially HP - have a setting that changes the amount of curl in the copy. Setting it for less curl turns down the fuser

I use genuine hp toner with great sucrose but with e bay orient transferPaper

Hi Martin. I think that this is a general problem with all newer laser printers. Under the constant pressure to save energy, new toners have been developed that fuse at lower temperatures. My old