开云体育

Hello Kevin, Friday, May 24, 2019 You should have done the holes and cut outs BEFORE soldering, then you can clamp pieces of square or rectangular section steel along the edge you will file and

Here is a photo that I use. [email protected]> wrote:

Jim: ? I just got some front panels made of PCB from JLCPCB.? They had a cutout for a 16 X 2 LCD, several holes for push buttons and a coupe of larger holes for a tuning control and a rotary

Yes. We get a scapping tool called laminate cutter . Very cheap as in India we pay less than 1$ Toppcb of enclosure is to be separated . Measure and mark with marker pen on either side. Start using

On 6/21/2019 10:00 PM, Jim Pruitt wrote: > I need to cut out an area of the top of a pc board enclosure (enclosure made using double sided pc board material).? The cutout is for a 16x2 LCD display.?

I need to cut out an area of the top of a pc board enclosure (enclosure made using double sided pc board material).? The cutout is for a 16x2 LCD display.? Can someone tell me how to do that and

Thank you Harvey that sends me off in right direction for future boards ect.

Thank you for your ideas. I have a surface mount tester and special probes coming from Bangood.com but 9 volt and usual5 mm resistor told me two different ends of super small Led. How to get specs on

On the bottom of the led look for a bar and a square.? The square is pointing to the cathode.? On the top of the LED, there may or may not be a green marking under the transparent plastic covering

"Kevin Byrne via Groups.Io" <kbyrne10@...> writes: I've found that the leads on my multimeter happen to have the correct polarity when in "diode test" mode. So I put it in that mode,

9 volt battery with resistor on positive red wire led lights up LED with black wire to green squares side. Triangle is bottom side down to board. Pictures are wrong. Thanks to your green squares

K is usually cathode( Greek kathodos( "descent" ) ) I think the dot in the "led_sch_top.jpg"" and the green squares "LED Bottom View.jpg" pictures are on the cathode side. But the picture Led Top

In the clipboard file are three pics of a SMD led project. Question is the green triangle pointing at K=Anode so as to buy this led in future from orient? I am new to surface mount and need this

Thank you for all your replies. Best Kevin

Yellow Wire modification to boards, especially very complex multi-layer boards is not uncommon in the military and space fabrication. If there was a design error in the brass board, subtle change

I use them to fix mistakes when I don't want to wait for a new board.? If it's the first revision, there's likely to be a design error in there in addition to the need for the jumper, or maybe I just

These wires are very often used to implement ECOs/FCOs (Engineering/Field Change Orders). I don't think it is as common now, but it used to be the case where it was fairly costly to spin a new board,

I stole from a websearch. was surprised there weren't more good examples. It's really an art-form in is own right.

Nice photo by the way. As long as it is connected good and transistor is heat sink protected while soldering all should be well I gather as a newbi home hobbiest only. No formal training.

Yup, I have seen some “big brand” names with “green wire”