开云体育

Although the PuTTY window opens, the "V" does not display on the screen when I type. I also am having trouble getting a simple Blink program to work on this board so I am begining to believe it is a

Hi Reed If XLoader reported back succesful upload, then the bootloader in the Mega must be working correctly, and thus the Mega must be a working board. When you connect to the Mega with Putty,

The PuTTY window opens with no effect.? Im going to load a blink program into the arduino just to make certain I am not chasing a failed board

That's great news. Now when you connect with just PUTTY you should be able to issue the v<crlf> command and get back 1.3<crlf>

I downloaded PuTTY as the terminal emulator.? I can see the Arduino as Com7.? When I run Xloader alone, seems to work and ends saying "29772 bytes uploaded"

Hi Reed I zoomed up the screenshot, and I can see that XLoader is unable to connect 73 Peter - GM8JCF

Hi Reed You need to install Tera Term or Putty, Windows doesn't come with a plain old terminal emulator these days unfortunately. Using the Device Manager you should be able to see a USB-SERIAL

I just tried a fresh boot of the system.? I cannot open a terminal window much less talk with the board I am at a loss here Reed

Hi Reed After uploading using XLoader, make sure to close XLoader, then launch Tera Term/Putty, ie only one program can have a COM port open at a time. 73 Peter - GM8JCF

I cannot connect with the device.? Looking at the device manager, the only com device listed is the Arduino.

Hi Reed After uploading the firmware, were you able to use Tera Term/Putty to verify that the firmware is installed and operating correctly ? ie To find out that the firmware is running correctly,

Hi, I am trying to get my Elektor SDR to work with my Arduino Mega2560.? I have run the program as administrator and followed the advice in previous topics.? I have used Xloader to install

Hi Ronald You are absolutely correct, there is NO description of these features in the QuickStartGuide unfortunately, mea culpa, sorry :-( As a general rule, when you hover the mouse over an item on

Hello, is there a manual describing the filters like NB(b), NR(b), Notch, IF Filter, AGC etc. ? Best Regards Ronald

No worries Markus, just very glad to hear that you are well on your way to get it up and running !! Perhaps I need to edit the Quick Start Guide to show right up front that you need to click the

Hi Peter, I'm very sorry, that I bothred you with this stupid question. If I had just kept reading the documentation, then I would have seen the solution myself. But I don't want to continue with the

Hi Markus Next on the right of the Power panel there is a Display panel, click the Full radio button which will display the G8JCFSDR completely including showing the Config button which will enable

Hi, when starting the program I get first the popup with the COM-port and then the popup with the text "modSetupRx.InitialiseRX..." (all this is described in the QuickStarter document). But then only

Hi Ronald I've never seen this error before. The files in the installer are most definitely NOT corrupted/damaged. If U have previously tried to installed build 282, then you need to uninstall build

I tried to install the G8JCFSDR on Ubuntu 20.04, Wine 7.0, 32-bit environment. WINEARCH=win32 WINEPREFIX=~/wine/G8JCFSDR winecfg cp ~/Downloads/setup_G8JCFSDR_282.exe