开云体育

Hi Herigs This is getting concerning to me :-( Does the test using Tera Term and the v command work ? see earlier post in this thread What sampling rate are U using ? Use 48000 until U have got

Hi Peter, I have same issue than Henk . Only 280 release is working. When I'm using 282, no waterfall appear and no possibility to change frequency. Herigs

Good Luck, let us know how it goes Peter

No problem for soldering with my Weller station! :-) I'm really curious to see how it works, a novelty for me. Thanks. Massimo - IK5FEV

Hi Massimo The UNO looks correct, and the SDR Shield is the V2.0 from Elektor which is also correct - note U will need to solder the header pins on the SDR Shield 73 Peter - GM8JCF

It was not the baudrate but there was no spectrum display i tryed al recommended solutions before finding a post where adviced was to download 280 that was in that post regards Henk

Hi. Before buying something wrong, I am attaching what I would have chosen. What do you think?? I need your technical opinion, can I proceed with the purchase? 73's IK5FEV Massimo

Hi Massimo Because the UK is no longer in the EU, my usual list of reliable UK suppliers would not be optimal for you - you will need to pay VAT, Customs duties and other taxes - so you should

Hi. You guys convinced me to switch to the new card! I start looking for the best offer on the web. Any advice, not from china? Thanks. Massimo IK5FEV

Hi. You guys convinced me to switch to the new card! I start looking for the best offer on the web. Any advice, not from china? Thanks. Massimo IK5FEV

Hi Massimo I use a chinese clone from eBay, very cheap, but long delivery time, and I would think that with current Covid restrictions, post from China might be even longer :-( The requirements of the

I am grateful to you for guiding me to understand this new world. In the end, I think I understand. I need an Elektor module and an Arduino module. By superimposing one another, from Pc I can control

Hi Henk That is very bad news to hear re 282, has anybody else had this problem, ie 280 working but 282 not working ? IIRC in 280, the baudrate was automatically set inside the G8JCFSDR to 115200,

Hi Frank Since the firmware V 1.3 has been successfully uploaded, you can use a terminal emulator, eg Tera Term, to connect to the UNO and directly send commands. So, start up Tera Term Set Baud Rate

Hello, my experience lately is that only version 280 works with the Elektor shield and not the newest version 282 regards Henk

How much of the advice of the book included in the kit did you follow? -- PE3ES / F4VTQ de Erwin

An update: Based on the magazine article linked on this page: https://www.elektormagazine.com/magazine/elektor-201607/29124 I downloaded the VB app designed to set the Elektor SDR Shield's frequency.

Hi Peter, thanks for the suggestion. "Allow desktop apps to access your microphone" is already set to "on," and G8JCFSDR Main Executable is in the list of desktop apps covered by it. Frank

Hi Massimo If U install the G8JCFSDR s/w on your PC, then the firmware will be downloaded to the Arduino UNO and it should just work !! 73 Peter - GM8JCF

Hi Frank U need to enable the Microphone (I think). Do Winkey+I, Microphone, Make sure "Allow desktop apps to access your microphone" is set to ON. See