¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Topics

P coupling Felder adapter to Hammer

 

Hi everyone.

I have an opportunity to procure a felder parallel cut guide that is designed for its P coupling system for felder saws. I currently own a hammer C3 31. Has anyone come across an adapter or suitable mounting method that could make this a worthwhile purchase?

the parallel cut guide is the same as here - ?

Thanks,
Nathan
 

Hi Nathan,

Over a year ago I was also playing with that idea and whipped up a quick prototype as can be seen in the picture below. It is/was the goal to make some 3d printed parts and use the VEIKO T ruler () To date, I didn't spent the time to get the design forward. Currently I am just using a stop block that I fix with an F-clamp. I fixed it on the top T-slot as I have my doubts about the strength of the side mounted T-slot when it comes to being loaded with a 60-70 cm plywood panel. Does anybody have experience with load capabilities of the side of the sliding table on a Hammer?



Regards
Bram
 

¿ªÔÆÌåÓý

I have been selling for years now, parallel fences to fit the Hammer and Minimax machines that bolt to the t-slot in the side of the slider. I do limit the width to roughly 25¡±-26¡± of support and no issues that I have ever heard of. I would not hang the Felder 1M extension on any sort of adapter on the Hammer slot arrangement, that would be asking for trouble.

Brian Lamb
blamb11@...
www.lambtoolworks.com




On Jun 27, 2023, at 10:50 PM, bram.baert@... wrote:

Hi Nathan,

Over a year ago I was also playing with that idea and whipped up a quick prototype as can be seen in the picture below. It is/was the goal to make some 3d printed parts and use the VEIKO T ruler () To date, I didn't spent the time to get the design forward. Currently I am just using a stop block that I fix with an F-clamp. I fixed it on the top T-slot as I have my doubts about the strength of the side mounted T-slot when it comes to being loaded with a 60-70 cm plywood panel. Does anybody have experience with load capabilities of the side of the sliding table on a Hammer?

<20230628_073452.jpg>

Regards
Bram

 

Thanks for the responses, I have come across your parallel fence which is very nice but unfortunately haven't been able to afford them including the shipping as im based in Aus. The one from Felder is in country and interestingly enough a little cheaper per unit price but its not a DRO.

Hi Bram thanks for your suggestion, ive found some other forum posts of people using aluminum extrusion and other things such as incra positioners, rulers etc which seem to function quiet well without adding too much lateral weight bearing on the t-slot.

Thanks,
Nathan

1 - 4 of 4