I worked with fellow FOGer Tom Fulmer on fine tuning the 3D printed dust chute adapter for the Hammer machines. After quite a few iterations I have a solution that actually works. Hopefull nobody printed the first one I posted, it was a pretty bad failure... that's what happens when I do things without proper measurements and engineering.
Any way, if anybody wants one, I'd be happy to print some, contact me off the list at blamb11@... I'll attach a 3D PDF file of what it looks like, which is easier to see how it all works than in pictures. It slips on the dust chute and then hangs off the metal ears sticking out off the sides.
I worked with fellow FOGer Tom Fulmer on fine tuning the 3D printed dust chute adapter for the Hammer machines. After quite a few iterations I have a solution that actually works. Hopefull nobody printed the first one I posted, it was a pretty bad failure... that's what happens when I do things without proper measurements and engineering.
Any way, if anybody wants one, I'd be happy to print some, contact me off the list at blamb11@... I'll attach a 3D PDF file of what it looks like, which is easier to see how it all works than in pictures. It slips on the dust chute and then hangs off the metal ears sticking out off the sides.
Does that clear everything? Pictures I have from Tom look like it wouldn't on the side closest to the blade. I had to remove the bolt on that side completely.
Brian Lamb
blamb11@...
lambtoolworks.com
On Tuesday, April 1, 2025 at 11:58:33 PM MST, JH via groups.io <drumboy122@...> wrote:
Not to be a killjoy but i recently designed the same: https://www.printables.com/model/1250208-hammer-c3k3-hose-connection
Jup it clears everything. Been working great for the past few weeks. I my case i added a slight bend forwards because if have to clear a homemade throughput for an extra on off switch on my sliding table. As can be seen in the picture below. Ican take a picture of the inside with the blade fully tilted if you want to.
Glad it's working for you. I only had pictures to go by and it looked like that flange around the top would hit the belt cover on the motor.
Brian Lamb
blamb11@...
lambtoolworks.com
On Wednesday, April 2, 2025 at 12:09:35 PM MST, JH via groups.io <drumboy122@...> wrote:
[Edited Message Follows]
Jup it clears everything. Been working great for the past few weeks. I my case i added a slight bend forwards because if have to clear a homemade throughput for an extra on off switch on my sliding table. As can be seen in the picture below. Ican take a picture of the inside with the blade fully tilted if you want to.
Sorry, didn't realize that the group was truncating the address. It is blamb11 at cox dot net, or you can alwass reply down by clicking below on all messages where it says "reply to sender".
Brian Lamb
blamb11@...
lambtoolworks.com
On Thursday, April 3, 2025 at 03:17:51 PM MST, ibsenafshar <brian@...> wrote:
Brian, I can't figure out how to get your entire mail address, but I am interested in the hammer chute
