开云体育

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Topics

Whitehill Hammer / Felder flush mount Combi Heads for long tenons ?

 

Has anyone here used the Whitehill Hammer / felder flush mount combi heads for long tenons? ?I have a felder F700z . ?I build reproduction furniture so i was thinking this head could be used to rough in 4+” tenons that I would finish plane in by hand. ?Would these heads used on an open shaper setup work well?
?
 

I have. And they work as advertised.? I find they are fit ready off the shaper and only occasionally need to refine them with a hand plane.?

I thought at first the head being on top of the spindle would cause an uneven cut, in practice however the head cuts even and clean.?

On Tue, Nov 12, 2024 at 5:47?PM John Deming via <jldjr26=[email protected]> wrote:
Has anyone here used the Whitehill Hammer / felder flush mount combi heads for long tenons?? I have a felder F700z .? I build reproduction furniture so i was thinking this head could be used to rough in 4+” tenons that I would finish plane in by hand.? Would these heads used on an open shaper setup work well?
?
 

Thank you Andy?
 

开云体育

I really like mine. 4” may require something done with guards.
Mark Foster

On Nov 12, 2024, at 15:08, John Deming via groups.io <jldjr26@...> wrote:

?
Thank you Andy?

--
Mark Foster
 

I bought mine for large tenon work and I can’t fault it.?
Set the fence up as a bump stop and the tenon shoulders work out perfect.

Kindest Regards

Jonathan Samways

Este mensaje se dirige exclusivamente a su destinatario y puede contener información privilegiada o confidencial. Si no es vd.el destinatario indicado, queda notificado de que la utilización, divulgación y/o copia sin autorización está prohibida en virtud de la legislación vigente. Si ha recibido este mensaje por error, le rogamos que nos lo comunique inmediatamente por esta misma vía y proceda a su destrucción.

This message is intended exclusively for its addressee and may contain information that is confidential and protected by professional privilege.If you are not the intended recipient you are hereby notified that any dissemination, copy or disclosure of this communication is strictly prohibited by law. If this message has been received in error, please immediately notify us via e-mail and delete it.



On Wed, 13 Nov 2024 at 00:29, Mark Foster via <mfsta2lt=[email protected]> wrote:
I really like mine. 4” may require something done with guards.
Mark Foster

On Nov 12, 2024, at 15:08, John Deming via <jldjr26=[email protected]> wrote:

?
Thank you Andy?

--
Mark Foster

 

Hi John, I use it all the time and with a bit of care, it will give perfect results.?
?
I'm helping Whitehill out in North America so feel free to reach out with any questions you may have.? I suggest you connect with Whitehill quickly to verify that the washer on your machine is compatible with one that they have available.? Sometimes Felder changes the design, and it's worth a check.? I can do this for you if you like,
?
Brent
 

Hi John, they work well, the only issue you'll run into is guarding.
?
The tenon hood isn't built for cutting rearward of the spindle, it's built for larger cutters forward of the spindle.
?
Regards, Rod.

1 - 7 of 7