开云体育

Is it better to reduce down to 5 beforehand?

David Best, So you use a 6” diameter dust collection hose for your dual 51, is the machines outlet 120mm? Thx, Wade

I would start by checking you start and run capacitors.? If the circuit trips after you let go of the start switch the issue is likely your run cap. Capacitors are typically the weak point in single

Going through the configurator on the Altendorf web site was quite interesting. There are a lot of options! I don’t know if the result is more like a sports car or a truck. -- John Hinman Boise ID

Hi Derek: A couple of questions below, all with thanks for taking the time to post. There’s a lot in your post for the forum! Cheers. * It is very nice to see Festo gear in your shop. I’m an early

I bought my F45 a few months before the IWF show which no doubt were selling lower than I paid.? The base machine is $39k then you add in automation on rip, scoring features, digital fence (+$5k),

Hi all, having a issue on start up and looking for some help Machine is a 2008 KF700 single phase. This machine I only used as spindle moulder, I've owned it for approximately 2 years and have had no

Thanks David, I understand better the sentence "Could lead to more problems", so I cross fingers that the technician can fix the cast iron table to something acceptable. From a phone discussion, the

David I would like to get your Survival Guide; I have tried PM, but it did not work and I couldn’t find any contact info on your site, so I apologize for this new thread. Please let me know how I

In my experience, it’s a lot more friendly to have separate extractor input hoses for jointer and planer modes on a large combination J/P. I hate wrestling with a long unwieldy 6” hose. Far easier

No. This is the one I thought was not as clear as it could be. Just suggesting more thorough specifications. Remove ambiguity where possible, Go verbose,

Are you talking about this one David? https://www.etsy.com/listing/1356539645/80-mm-hose-union Bill B [email protected]> wrote:

Bill, I would also suggest you specify if a dimension is inside diameter (ID) or outside diameter (OD). I was looking at your 80 x 80mm connector wondering just that. I’m needing 80mm OD to OD for a

Wade, Yeah, if you have a long enough hose you can do that. The request is really for the adapter. These 120mm ports are basically 5”. I would like to connect a 6” hose to reduce the hose CFM

Great suggestion Brian! Thanks Bill B [email protected]> wrote:

Mark, thanks for your response. I did get it that no one was suggesting that simple deflection is the only possible cause of the dip near the trunnion. However, this idea did get most of the coverage

Jason, I wondered the same thing. I believe a Felder saw with the same safety feature is about US$45,000. if it was a $5,000 upgrade to my K700S I would have bought it. Adding over $30k put it out of

Aaron, Do you remove the collector hose each time you turn the operation over on the jointer/planer combo machine? I was thinking that if you have some extra “slack” in the hose length, that it

Hi Bill, One of the things I’m going to ask from you is a “120mm port to 6” hose adapter”. So that we can quickly connect/disconnect a 6” hose from things like a Felder jointer/planer and

You might want to add to your Etsy listings the sizes that the adapters fit. Say the rectangular, list it fits over a 30mm x 80mm port and fits a 4” hose on the outside on the round end. That way