I ordered my Profil with provisions to provide power for the feeder which it does well.?
The outlet is on the back left side just below the second dust port and uses a European style plug which is available from Felder and is very reasonably priced.?
The feeder power operation is not available when the spindle is not turning and has an 8 second startup delay which allows the spindles Star-Delta start cycle to complete itself before powering up the feeder.?
Like Joe Doherty, I use the Cometic DC40 feeder. It has digital start/stop and variable speed built in and because of this it needs to be turned on manually when power is removed which occurs when the spindle is stopped (either with the stop button or emergency stop button).?
Since I don¡¯t typically dry run the feeder this setup works fine for me.?
If i wanted the feeder to start when the spindle is turned on then a standard mechanical on/off switch like the Felder, Steff, and older style Comatics have would be better choice.?
I hope this helps.?
toggle quoted message
Show quoted text
On Jan 11, 2018, at 2:42 PM, Bellsouth
dohertyj@... [felder-woodworking] <
felder-woodworking@...> wrote:
?
Gary,
That is interesting.
There must be options that can be set.
I think John Ferandin¡¯s Profile 45z has a time delay then starts the feeder after the spindle is started and then the feeder stops when the spindle stops.?
I never hooked my feeder to the shaper plug because I did not want to the feeder to start and stop this way.
Joe in New Orleans
My DC40 Comatic does not automatically start with the Profil 45 shaper. ?It is 3 phase, plugged into the shaper, installed by Felder tech.
Gary
Gary Blasingame195 Red Fox Run
Athens, Georgia 30605
706-353-8629
706-540-2130 (cell)
?Hi SW,
I run the Comatic DC40 smart feeder with single phase 120 volt. ?Since the DC40 converts AC power to DC it is possible to move some jumpers and run the feeder with single phase or three phase and with 120 volt or 240 volt.
I like to control the power feeder independently of the spindle power on or off. ?I would like to have it set up so the power feeder stops when the red power off button is pressed so that is something is going wrong the feeder stops with the spindle. ?But that is not possible when using 120 volt as the KF700 supplies whatever power it is running on.
If you are running the power feeder from the plug on the KF700 then it will power on and off with the start stop buttons for the shaper or the saw. ?I don¡¯t like the power feeder running when I am hand feeding something. ?I suppose I could turn the feeder off with the feeder controls.
If you are considering the Comatic Smart Stand for your Comatic feeder I think it is too large to use on a KF700. ?A three wheeled feeder with standard stand and lift assist device is ideal for a KF700.
I think 7.5 HP is enough power. ?I have not found 7.5 HP to be a limitation on my Profile 45z shaper. ?
