Re: Saw blade for cross cut.

mac campshure All Messages By This Member #140680 开云体育 Way too many teeth called to make a great blade that’s inexpensive and I think it’s 300 diameter and 20 tooth maybe or 28 tooth AB replace. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330?cell airtightclamps@... Designing and building for 50 years toggle quoted message Show quoted text On Mar 31, 2025, at 8:25?AM, imran via groups.io <imranwoodshop@...> wrote: ? Chris, I should have added that in my experience one does not need high tooth count for cross cutting solid wood. The PN I shared below, you can see in application column, is recommended for veneer plywood. Imran Malik IAM Wood Creations On Mar 31, 2025, at 9:13?AM, Imran Malik <imranwoodshop@...> wrote: ?Chris, Below is a response I posted some time ago on my FB group. Here is the list of blades from Tenryu for sliding table saws and the PN for ATAFR is?IW-300100AB3

***

It is very helpful to think this out. One should try to get all blades with same kerf so all scales and riving knife remain true.

I started with Felder silent power (315 mm, 28 & 48 teeth ATB) on my 2002 KF without scoring option and the are fine. 3.2 mm kerf. I can’t comment to what max blade you can use with and without scoring on your KF but it should be in the manual.

I have been using Tenryu on my K975 and they are good blades. 300/350 mm dia and 28, 50 & 32 teeth ATB. 350 does not go under table.

IW-30028CBD3 (0.128 kerf)

IW-30050CBD3 (0.128 kerf)

IW-35032CBD3 (0.136 kerf)

David P Best uses the 50 teeth above for both rip and xcut and says it works fine.

Sliders do work better with less hook so do look for blades specifically made for sliders. Hopefully this helps.

Imran Malik

IAM Wood Creations

On Mar 31, 2025, at 7:35?AM, Chris via groups.io <Hope752@...> wrote:

Hi there all, I'm sure this has been discussed many times here, but I'm looking for a cross cut blade for my kf700 for hardwoods. Material thickness 30mm+

I have a tenryu 60 tooth blade and it has been good.

Looking for an 80ish tooth 300mm blade and thinking ATAFR grind to give a flat cut (crosscut rebating) but am unsure when it comes to kerf and particularly rake. Positive/ neutral/ negative for hard woods. I assume a thinner kerf is the way to go?

Tenryu PP-30075AB 300mm -75 tooth looks good but $310 aud.

Please any recommendations on specs/ blades

Thanks again.

Chris.

开云体育

Re: Saw blade for cross cut.

开云体育