¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Gear oil


 

¿ªÔÆÌåÓý

Oliver redesigned the 299 to the square corner casting in the 1960's.? It is possible that grease was used rather than oil, even for the cutter bearings.? I'll find out.? I had a late model 299 but memory fails me.? My Oliver jointer ran iso 68 but the planer might be grease.? Chuck Hess should know for sure.? He has a thread on a rehab of a 299 .? Look for Hesswoodworks.? Dave


From: [email protected] <[email protected]> on behalf of taylor donsker <tdonsker@...>
Sent: Monday, July 15, 2024 10:08 AM
To: [email protected] <[email protected]>
Subject: Re: [FOG] Gear oil
?

[Edited Message Follows]

Amazing. Thank you david! I could not find the info for the life of me.

Being a later end of the second generation design (1968 or so), everything has zerk fittings.

Join [email protected] to automatically receive all group messages.