If keep tools around that you are familiar with using, you will always end up finding an excuse to use them...In which case why did you upgrade?? I only have the slider, no cabinet saw. Keeping another table saw was never even considered.?
For ripping, I either use a parallel guides ( I do need to upgrade to Brian's version) and clamps, or the F&F jig. I keep a 500mm rip fence (Felder?410-099)?on the machine and use it as a bump stop.? ??
Dados are not a big deal to me.? On my machine it is 4 screws to change the table insert and the screw that holds the blade.? I can change over in a couple of minutes.? It does take a little planning to limit how often I have to change over.? I try to draw everything in cad first and consider change-over when I make my cut list.? ??
Honestly, after using the slider and learning how to properly support and clamp the workpiece, I have zero desire to ever use a cabinet saw again.?
-Kyle
