Great article. I don¡¯t own parallel clamps and wondered about calibration, so both clamps are identically set. Great simple jig shown by Lucky to accomplish this.
Imran
toggle quoted message
Show quoted text
On Feb 18, 2022, at 1:21 AM, David Luckensmeyer <dhluckens@...> wrote:
?
Haha on the butt bar comment. Aussies rarely say ¡°butt¡± as we prefer ¡°bum¡±. But I figured ¡°bum bar¡± wouldn¡¯t wash. If I had any more English blood in me I¡¯d have tried ¡°arse bar¡± with the editor to see if that would slip through!
I regret those loose fitting jeans shorts now. Shoulda donned the pink tights!
Lucky
First time I¡¯ve seen the ¡°butt bar¡± workflow accurately covered in a magazine - with photo. ?Seriously, this is a terrifically concise and practical article. ?
<image.png>David Best - via mobile phone?
On Feb 17, 2022, at 9:14 PM, Bill Belanger <Bill@...> wrote:
?
Where can we find that article?
Thanks?
Bill Belanger
I¡¯ll second that.? Great article - and especially helpful for someone new to the sliding table saw. ?
David Best - via mobile phone?
On Feb 17, 2022, at 8:54 PM, PK <pk@...> wrote:
?Lucky,
Very nice work!? You did an amazing job of articulating why we all love our sliders.? Also great to see the kappa 400 x-motion in pictures!??
Lots of shout outs to people on the FOG too! Mac's clamps, Brian's parallel Fence and lots of ideas from everyone too!
Thank you for adding value in the woodworking world!
PK
PKwoodworking
imran