开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. Eurovanupdate
  2. Topics

Anyone know how to remove an AC condensor from a 1995 EVC (Winnabago)

 

I am replacing my AC compressor, dier, expansion valve and Condenser tomorrow morning with the help of a friend and am unable to figure out how to remove the condenser.? It is trapped by a plastic trim piece at the top under the metal core support which is held in place by two rubber bumpers that I cannot find how to release/remove.? Also trapped at the bottom by a plastic tray.
 

开云体育

Nothing in the Bentley about it. Check the files section for that other service manual for possible clues.?

On Feb 3, 2025, at 11:05, bcolins via groups.io <briancollins.tx@...> wrote:

?
I am replacing my AC compressor, dier, expansion valve and Condenser tomorrow morning with the help of a friend and am unable to figure out how to remove the condenser.? It is trapped by a plastic trim piece at the top under the metal core support which is held in place by two rubber bumpers that I cannot find how to release/remove.? Also trapped at the bottom by a plastic tray.
 

I have never removed just the condenser, but when I pull the front end off I just kind of swing the whole rad / condenser assembly out of the way.? What is the major roadblock?
 

@bcolins, Did you figure out how to get the core support off?? I replaced my radiator this week and I knew exactly what you were talking about when I read this message.?
?
The rubber bumpers on the top are easily pushed through with a screwdriver and little lubricant like silicon or alcohol. I removed the plastic grill and the metal fascia about the bumper to access the radiator. It also makes it easier to move the condenser if you remove the headlight on that side, which is only 4 screws.?
?
Good luck,
Kent

1 - 4 of 4