Hi Rick This topic has been extensively covered in the Group so do a search and you will find loads of information and suggestions ? Feel free to ask anything that is not covered We do not use the ¡°Chat¡± feature as it has limited exposure , and is not searchable so does not add to our body of knowledge Kind Regards Carvel Co Moderator
?
From: [email protected] [mailto:[email protected]] On Behalf Of teamricky.m via groups.ioSent: Friday, May 23, 2025 2:17 PMTo: [email protected]Subject: [emcoV10lathe] Headstock alignment
Hi Chaps,
I have a bad alignment problem!
0.125mm taper over 125mm cut with spring passes¡. I¡¯m ok with how to test but rather than trying to move the headstock without asking seems to be a problem!
Im hoping others here have done the set up and could point me in the right direction ;)
Any help would be most appreciated!
Cheers Rick
