开云体育

Wanted to take? moment to report something that just started to appear when starting Direwolf. I have not previously seen these messages regardong the CM108 PTT dll and thought it best to report

Hello John, Stepping back a moment, I re-read your original email and I think I was confused. Are you wanting to do what this following this doc proposes or are you trying to do something

David, just another possibility to consider. eas2aprs.py specifies channel 0 as the output for the aprs packet constructed from reading the eas input created by the sdr. Does the TCP port receive

Hello John, Ok Why is Direwolf running on Computer B? You made no mention of this before.

<direwolf-groupsio@...> wrote: stopped aprx with systemctl.

Hello John, Ok. After you restarted APRX on Computer B,

Hi David, please see below.... I assume you are running this on "computer A". ?Correct? YES I edited aprx.conf so the relevant section looks like: <interface> tcp-device 192.168.1.153 8001

Hello John, Ok I assume you are running this on "computer A". Correct? This all looks fine where the top line is showing your kissutil running on Compu

I apologize for this long post in advance. I am interested in revisiting the original issue described in the beginning post of this thread. An EAS sdr receiver has been operational at my station now

I bought another rlt-sdr device? named "RTL2832U+RB820T2 USB"? ?Use the same start command , it worked well. this is the running log with it root@raspberrypi:~# rtl_fm -f 144.640M - | direwolf -c

Progress! I got the 1.8 DEV version built and running. I see the GPIO25 line go high when re-transmitting a packet. To recap: I did not downgrade the Pi firmware, I did not revert to an older version

Sorry, I just re-read you post and you have the '-' at the end of your direwolf command. I have no other ideas that might help

Here is the startup command I use with my rtl device. It has been working for several years on direwolf 1.3. I think you might be missing '-' at the end of your direwolf command. rtl_fm -f 144.390M -

re: How is the git command to get the DEV release? User manual, section 5, page 24: ( https://github.com/wb2osz/direwolf/blob/master/doc/User-Guide.pdf ) At this point you should have the most recent

Hi David, Yes. I agree with you. I've tried (not with DEV release) putting in cfg the gpiod line, and it gives the error about RTS that I've read here. How is the git command to get the DEV

RTL_FM is outputing outputing to standard output and Direwolf is listening on TCP/UDP channel. Change your ADEVICE to listen on standard input - see manual as I don't have access right now and don't

Hello I set up Direwolf on a raspberry pi 4b? + rtl-sdr v4 an an Aprs only rx IGate. I can find the igate on aprs.fi , But? when i tried? send aprs radio with my aprs device,it seemed that my Aprs

Hello Rafa, Reverting to an older kernel and firmware is not ideal as you will be missing on various security fixes, bug fixes, etc. on both the kernel and the firmware. For impacted Bookworm

I've found a temp solution of the GPIO issue. *rpi-update cac01bed1224743104cb2a4103605f269f207b1a #6.1.54* with this command, and a reboot, you restore the function of /sys/class/gpio 73's Rafa

Hello Robert, Can you be specific on which document you're following? Btw, I believe this impactful change is only for the Bookworm OS release running the new 6.6.x kernel series. Bullseye with