开云体育

Update: I changed the starting command and it looks like it is almost starting except for 1 error I noticed the rtl_fm:invalid option and changed it back to -f but then it freezes like before

Hi I typed it in and I didn’t get as many errors but it freezes up and doesn’t return the command prompt, plus I don’t see it listed on the map It still cannot open the sdr.conf file, in bold

Hi, I’m using the command line from the powerpoint rtl_fm -f 144.39M - | direwolf -c sdr.conf -r 24000 -D 1 – For the original steps I was using the powerpoint from direwolf I have the

Hi David, I'm on Windows 10 and I don't have build tools setup. The latest on the releases page is v1.7 A. Should I move to the stable branch?

Hello Danny, Direwolf v1.7A is a rather old version of the DEV branch as the current version is 1.7E: grep "Dire Wolf DEVELOPMENT" src/direwolf.c -- dw_printf ("Dire Wolf DEVELOPMENT

Hello Clinton, For the "original steps" you were following, where did you read those? Do you have a URL? Can you describe your setup? Since you 're showing two radios here (a Baofeng and a RTL

Hi, I finally figured the issue with the install (updated commands are helpful) but when running direwolf I get the following errors. My set up is a baofeng UV5R+, RTL-SDR receiver R820T2, raspberry

I have direwolf configured with AGWPORT 0 KISSPORT 8100 But when I start direwolf I get two KISS ports Disabled AGW network client port. Ready to accept KISS TCP client application 0 on port 8001

I was getting errors when I ran sudo make install and after, but I found the updated commands and was able to install but I get a bunch of errors when starting direwolf. Sent from Mail for

I was in the build directory. I finally found some updated commands and ran them and was able to finish the install but I’m getting a bunch of errors when I start direwolf. Sent from Mail for

Exactly what commands did you use?

Hei, In what directory you gave the command? sudo make install should be run in the build directory. I use thehe commands: cd ~ git clone -b dev https://www.github.com/wb2osz/direwolf cd

Hi, I followed the directions for installing direwolf on a raspberry pi and everything was working but when I get to the sudo make install command I get the following: make: *** No rule to make

Thanks much. It looks like it worked for the Libasound2. I'll continue with direwolf. 73, Larry? WB8LBZ El Paso, TX

The "elpa-magit" error is probably the result of trying to install "git-all" rather than just "git". There are some other issues with the out of date build instructions. Use the instructions

Hello Larry, I looked over that documentation and while it's nicely written, it's recommending some obsolete things like removing pulseaudio, I bet when you did that, it asked you to uninstall a lot

I am in the process of trying the install process described in the https://n1aae.com/raspberry-pi-aprs-direwolf-linux-igate-digipeater/ guide. This is a Raspberry Pi3 with the latest January 28th 2022

KISS protocol set TXDELAY = 30 (*10mS units = 300 mS), port 0 KISS protocol set Persistence = 63, port 0 KISS protocol set SlotTime = 12 (*10mS units = 120 mS), port 0 KISS protocol set TXtail = 3

As a quick follow up, what are your settings for slot time and persistence per the Direwolf User Guide section 9.2.13? You can learn how these two values are used to determine when the frequency

Yes, DCD is "0" before my TX every time so the TX INHIBIT function seems to be working.? It seems as though my issue is from DCD dropping mid-packet and then my station immediately jumps on the false