开云体育

For all who's interested, or as reference: After implementing my circuitry for a PTT interlocking and DCD sharing solution combined with Direwolf, I can confirm Direwolf holds the frames in queue when

Yes that is the feature: Power Control.. If the station is transmitting weather, the radio does not need to be powered on most of the time. However, with a bit more functionality, it could be powered

Hi Robert, If Direwolf is running and occasionally sending a packet, shouldn’t it be the one to turn the radio on and off? The Tracker2/3 could turn on a radio, send a packet, turn off the radio.

You are request the same feature as the Power Control feature. As If I am reading the Argent Data manual, the feature needs to:?? a) Activate a GPIO Power Control pin (to power up the radio)?? ?

Fred,What are you running Direwolf on? If it's a pi, you could use the GPIO and a relay to handle the radio power.??Probably could be done with about any system.? Rob GiulianoKB8RCO On Thu, Jul 15,

Greetings, I am looking to power up a radio, send a packet, shutdown radio. I had this function on the ArgentData trackers. I am not seeing a reference to this option in the documentation but then I

No need to use ALC input, better not actually... Having a good solution, preferably in software, with PTT interlock and DCD sharing across some channels will do the job. No need to involve any ALC

How about using the ALC input ?

Hi all, I'm about to implement and test with the TRANSMIT INHIBIT INPUT too for some special purpose. For success it's imported it queues the frames and TX-es them when the TXINH input is released.

That looks very nice Craig and some of your other projects on Github look pretty interesting as well! Thanks for posting those. --David KI6ZHD

I have used Direwolf on Pis and never seen this message with GPIO, or VOX. Since this was a slightly different installation of my client, I looked through my APRS client to see if there were any

Audacity and or AlsaMixer are relative readings, similar to an uncalibrated S-meter.You can read the manuals and know what the radio is outputting - especially when using the radio's data jack.? They

if anyone is interested, https://www.youtube.com/watch?v=NJ_IJNU7NA0&t=7s https://github.com/craigerl/direwatch

You can buy the Fe-Pi designed HAT from the new design owners below: https://wb7fhc.com/about-the-fe-pi.html --David KI6ZHD

Direwolf is really very forgiving on RX levels but the general guidance is that it's average receive level is around 50. I can't comment on how the alsamixer setting might look within in a zoomed in

Ok.. that takes the iffy Raspberry Pi USB stack out of the running. When no PTT is configured, it's assume you're using VOX or using a sound device like a Signalink that asserts PTT for you. Per the

The error came on a older x86_64 KUbuntu desktp homebrew computer, with the motherboard sound card, and no PTT setting (VOX).? Direwolf has "no clue' how the PTT is being handled. In fact, the

Hello Alejandro, I would recommend to start with confirming that your HT can hear your Direwolf station (XE1GNU-1) beacons. Per your configuration, those beacons should be sent every 5 minutes. Is

Hello Rob, If you google the following term: direwolf "Transmit timing error: PTT is on" "mSec too long" You'll see a few hits and one one of these talks about the issue being known on non-Raspberry

I used the config file you proposed and it appears to be behaving now. I am getting an error 1.7-dev-A that is????? Transmit timing error: PTT is on 104 mSec too long.? I am using VOX (no PTT