开云体育

Hi Martin This worked! ?Now have Dierwolf running with PTT support for the digiRig lite interface. ?I now realize I missed that the path to correct source was different from the main repository.

Yes, that happens if you use the "-p" command line option and don't read anything from the pseudo terminal. The operating system buffer fills up and the write fails. Solution:? Don't put "-p" on the

Good morning Anyone ran across this? KISS SEND - Discarding message because no one is listening. This happens when you use the -p option and don't read from the pseudo terminal

Hi Larrie, The main Direwolf repository does not (yet) include support for CM108 on Mac. I submitted a Pull Request back in November 2023, but while the changes were Approved, they haven't been

I have reviewed the many posts on this subject but did not find anything that has worked in my case. Running Mac OS 15.3 Installed Mac Ports Installed Direwolf, building from source. I installed the

Hello Steven, I'm not sure what you mean by "digirig mobile devices don't support CM108" as they DO have a CM108 chip inside them. Next, while there might not be a way to uniquely rename the

In my case, I've become convinced there's no easy way to rename these devices.? And because digirig mobile devices don't support CM108, I'm just out of luck.

Several of us running BPQ systems on 40m have been using IL2P 300b for several years now centered at 7103.3 so?unless you adjust the default 1600 / 1800 tones use USB dial 7101.6 or LSB dial 7105. It

There are two different independent concepts: (1) Modem (L1) which converts between an audio stream and data bits with no structure. direwolf supports the V.26B QPSK mode used by MFJ and a couple

This list really isn't so much about operation but Googleng around, I see: /g/bpq32/topic/il2p_in_hf/107684529 --David KI6ZHD

I started playing with DW, and things are working. At least I can decode some HF traffic. I wanted to try out IL2P, and read through the documentation. I have a few questions: Does DW implement all

Thanks for the reply. I tweaked alsa, rig, and backed off the Signalink tx. Found a sweet spot and seems to be working. Sent from [Proton Mail](https://proton.me/mail/home) for iOS

Lower audio out from radio or lower mic on computer

The ARISS site is more "plan" than short-term actual. It can lag behind if there's a surprise situation, but will eventually catch up as it has now. A better view is here, based on reception

Ariss.org has a page showing the status of amateur radios on the ISS. https://www.ariss.org/current-status-of-iss-stations.html. I found this by searching the web for iss radio status. -- 73 de Jay,

Thanks for the reply, David Sent from [Proton Mail](https://proton.me/mail/home) for iOS

Physically turn down the RX knob on your Signalink a little bit to lower the audio input level. --David KI6ZHD

Hello Rick, Yes... please see the https://github.com/wb2osz/direwolf-doc/blob/main/Radio-Interface-Guide.pdf documentation as well as the Direwolf email list archives. --David KI6ZHD

Good day! I’m using a signalink with a mobile rig along with Direwolf. The OS is Linux Mint. I made good progress last night with the aprs setup but noticing “audio input too high” I’ve

Good evening It's been a while since I've used Direwolf - I am using Linux and a Signalink...Trying to jog my memory about the following: Here is one example: N901EN audio level = 118(10/9) ?