开云体育

Thank you David for your patience, problem solved. -- Regards, Phil

Configured as iGate R|T or digipeater?

Hello Ian, It would be best to correct your terminology up front so we avoid misunderstandings. The "-1", "-2", etc items are called SSIDs and what you're calling "nodenames" is probably just your

Hello Josh, You haven't given much information here to help you. What operating system are you using this SDR on? What SDR application are you using with your Nooelec SDR (aka an RTL-based SDR

I just realized tha this will also disable packet acknowledgments and the connection will hang and tiime out. So: - make both stations the same SSID - make one purely receive only: it cant transmit

As. you note, you must use different SSIDs for each site. And each site would then be accessed independently based on their SSID. You can then go between sites and compare behaviors. You can have a

Hello Phil, Nono.. you misunderstand. When I say "default" I literally mean it: ADEVICE default The word "default" is a PulseAudio/Pipewire special device that will send/receive audio to any

I have 2 sites - my home and my bunker.? I own both buildings and they are about 10 miles apart and in 2m contact.? The bunker is NOT residential it is commercial. I would like to run packet radio

Hi Josh, I'm surprised that you expect Direwolf to "see" any SDR. Direwolf looks for audio devices, not SDR receivers/transmitters. In order to use Direwolf to process the audio from a SDR receiver

I am at my witts end. I have been trying to use my Nooelec SDR with direwolf and direwolf does not "see" it and place it in the list. I have teied all releases from 1.5 to 1.7 to see if there is a

Ramon: Sorry, never got notified you had replied. I'm now digging into it on the Lenovo, prior to moving it into several other setups (Pi3B, VB VM docker host, XCP-NG VM Docker host. Got several

But... there is only one audio device and that's the "default" device. ADEVICE plughw:1,0 This is used when the FT-991A? is connected and Direwolf works. ADEVICE plughw:0,0 And this is the only audio

Hello Phil, Right.. and with using a different Direwolf "ADEVICE" setting in the direwolf.conf file, this should work Yup.. very true though GQRX's AX.25 decoder can't touch the weak signal decoding

Hello David, My understanding is that the default audio device is the ALSA device. I'm probably wrong and I'll test that idea. I was receiving SSTV from the ISS using SDRconnect and QSSTV. When the

Hello Phil, This is not entirely true. If you configure Direwolf to use an ALSA device, you're right.. Direwolf will want exclusive access to that sound card. Now, if you configure Direwolf to use the

It's a possibility I suppose Neil and thank you for your reply. I'll think about it. -- Regards, Phil

That's not the case John, but thank you for your reply. If I connect my Yaesu FT-991A to my laptop then a new audio device becomes available, Burr Brown or some thing like that. I cannot use the radio

If other applications can get audio from SDRconnect, direwolf should also be able to. What audio device name is used by the other applications? 73, John WB2OSZ

You could get a cheap soundcard dongle, configure direwolf to that and use a short 3.5mm TRS patch cable from the computer headphone out to the soundcard dongle Mic input. Neil G7LHA

Hi Cassie For an FM RX channel one would expect a much higher audio level with zero received signal. ie try increase the slider to around 100% for a start. The way to adjust is on an actual signal