开云体育

Yes Sir, that's what I did during my experiments and investigations. In the meantime I've managed to get my system running in good order. Thank you for your request. Greetings. Karl, DK7AL Am

there are a few Digirig models; lite & mobile and sub models as well; read carefully to make sure it features are correct for the application. if you want CAT control for your radio make sure the

have you run : aplay -l & a record -l to see what devices are on your ports ?

AGW will do this very well. On the Raspberry Pi with the radio (rpi#1), run Direwolf with AGW enabled. Then on the other Raspberry Pi (rpi#2), setup your APRS application to use AGW and put in the

Is it worth doing at the basic private network level? ie make the non internet connected network route through the connected one? Lots of options here from straight routing and gateways to masquerade.

I want to link two separate PCs (or raspberry pi's) running on two separate routed networks similar to a KISS client/server configuration. Both networks have access to each other but only one has a

Hi Karl You have a pulseaudio installation. In many (but not all) of the basic Linux distributions the user cannot access the ALSA device directly, instead pulseaudio does that. This explains why on

(1)?? Is the satellite transmitting AX.25? (2)?? Why do you have "ACHANNELS 2?"??? That is for stereo input (3)?? Why do you have "MODEM 1200"? when you want to receive 9600? (4)? How are

Hello all, For background- here is the last topic I had on this project, which goes over my setup. /g/direwolf/topic/108025301#msg9801 Basically, 2 computer ground stations set up

After a heavy tinkering session with the CM108 USB sound card this morning I managed to separate the bindungs of the USB sound card modem from the sound system of my Linux box. Now I can operate this

Good morning folks, I have a Linux box and the problem, that "ADEVICE plughw:1,0" in the config file does not work without complaining that a resource or device is busy. But commenting out this

Okay, appreciate it.? Suspected it could be an issue because I did notice a delay and hang time on radio.? Was just throwing me off because I could clearly see messages coming through before winlink

The direwolf Radio Interface Guide https://github.com/wb2osz/direwolf-doc/blob/main/Radio-Interface-Guide.pdf section 7.4 explains why you don't want to use VOX built in to the radio. You need to use

Hey, I've spent a few hours looking for a solution to this,? Sound card is setup correctly, packets are being sent via VOX (uv-5r), stations are replying.? However it seems winlink is disconnecting

Thanks John.? I'm looking into that.

No the sound cards don't have unique identifiers anywhere I can find.? I'm using a RPI4b. Thanks for the advice.

tnx

There is an easy solution. This situation is covered in section 7.6 of the Radio Interface Guide. https://github.com/wb2osz/direwolf-doc/blob/main/Radio-Interface-Guide.pdf 73, John WB2OSZ

Yeah, this is a system thing at not a Direwolf thing per se. Do these two Digirig units have unique serial numbers? You can see all the complete details by looking at the output of "sudo lsusb

Yes. Run the 'cm108' command. It will identify the USB devices by their ports. It will show you how to make a 'rules' file. Good luck