开云体育

Happy Christmas and New Year to you and your family Adam. Santa just left NZ so he will be with you shortly.. ? Nigel de ZL1NAY

Thank You Very Much Adam ! Merry Christmas to You and Your Family and I hope you have a Great New Year. You had a very productive 2023 and I'm sure 2024 will be even better. I'm looking forward to

Guys, Merry X'mas and Happy New Year 2024! I hope you all have great time with your family and friends. In 2023, we have announced ADX-S, CPK-1 Pixie2023, CPK-2 DC40 and CPK-3 KT. I have enjoyed?

Mark, Try to shut down your monitor for a while and check the waterfall. Are your audio cables original length of about 0.5 meter? Sometimes if you mix these two cables, you will see no signal but

I'm using my ADX-S with a DigiRig and WSJT-X running on both Armbian OS and MacOS machines. I have successfully completed FT8 QSOs and have been spotted transmitting WSPR. However in all modes I'm

A dental floss plastic case will be a good home for the KT receiver. Thanks, Adam

Barb, A long wire of 5 meters will help if it is connected to the whip antenna. Even without the additional length, the whip is doing well here in China as the local SW stations are so strong. Thanks,

Adam, I agree on red led instead of ?green led for tuning. I must confess that I didn’t read your build manual and was rushing to finish and test. Didn’t pay much attention which led goes to

Barb, Thanks for the photos and video. It looks great. One little thing is that it is better to use the red LED for tuning as it is brighter. Try to connect to your ham radio antenna and experience

Adam mailed me a KT-CP3 radio kit which I received yesterday and build it in half an hour! It was a breeze to build this little kit! Then I connected it to my external speaker and shoot a short test

Thanks guys for the orders! I have shipped the first batch earlier today, and more to follow tomorrow. Based on the feedback from my shipping agency, the post office tracked air parcel is quite busy

Guys, Based on the very positive feedback from our domestic customers, I have updated the web store to include CPK-3 KT Receiver. The unit price for the kit and the mini whip antenna including tracked

The following files and folders have been updated in the Files area of the [email protected] group. * /KT/CPK-3 KT Receiver Assembly Manual(draft2).pdf (

Thanks for the first report. It looks good. VAR - band switch by SPAN potentiometer (FM/MW/SW) FAV - band setting by 5.1k resistor ~ SW 13-14.3MHz Thanks, Adam

Took me about 30-40 minutes start to finish, including cleaning flux off of board. Soldered radio IC first. I am still trying to see what the FAV/VAR pins tune, appears to be maybe SW 12Mhz. Still

Looking forward to the first report from abroad. Thanks, Adam

Adam, I received mine on 13 Dec. Going to heat the soldering iron this weekend. Thank you JP KA3BWP

Guys, We have upgraded the shipping firmware from V1.1 to V1.3 so we ask you to add a 3mm red LED to the CAL and GND test pins at least. You can find the LED in the kit in pink plastic bags. If you

Guys, While you are still waiting for the parcel patiently, about 6 dozens of domestic customers are enjoying this tiny radio now. A newbie told me in my wechat group that he just bought a soldering

This blog further explains the schematic: https://mp.weixin./s/_i-NhGwdAhC8272gbw50Cw Thanks, Adam