开云体育

Took me about 30-40 minutes start to finish, including cleaning flux off of board. Soldered radio IC first. I am still trying to see what the FAV/VAR pins tune, appears to be maybe SW 12Mhz. Still

Looking forward to the first report from abroad. Thanks, Adam

Adam, I received mine on 13 Dec. Going to heat the soldering iron this weekend. Thank you JP KA3BWP

Guys, We have upgraded the shipping firmware from V1.1 to V1.3 so we ask you to add a 3mm red LED to the CAL and GND test pins at least. You can find the LED in the kit in pink plastic bags. If you

Guys, While you are still waiting for the parcel patiently, about 6 dozens of domestic customers are enjoying this tiny radio now. A newbie told me in my wechat group that he just bought a soldering

This blog further explains the schematic: https://mp.weixin./s/_i-NhGwdAhC8272gbw50Cw Thanks, Adam

Adam, thank you for sending this helpful information about this receiver kit. I assume that R2 can be my band of choice according to what Ohms I have on my Resistor (According to the chart). Neat! I

The following files and folders have been uploaded to the Files area of the [email protected] group. * /KT/CPK-3 KT Receiver Assembly Manual(draft).pdf (

Thanks for sharing. Nice blue box. The final 2N2222 might help the RF output if you QSY to 20m band. Thanks, Adam

I have been very pleased with my pixie 2023 and it’s clear receiver and good transmit output. I converted it to 20 m by changing the final output filter to 56 uH , 220 pf 0n both caps. Crystal on 20

Matt, Thanks. Shipped and the tracking number is updated in PayPal. Congratulations on the new article on CQ-DL. At the same time of February next year, Japan QEX will publish a long long article

Hi Adam, I ordered one ysterday via paypal. By the way, in February a report about the ADX-S will be published in the german Ham Radio journal CQ-DL. The report was written by me ;) 73 de Matt, DL1SER

I’ll take one if there are any left of the beta kits. Please send ordering info . Thanks.

Okay. Shipped 6 kits today and 4 kits left for beta. Thanks, Adam

Hi Adam, I’d like to build one too if you have any left. How can I make the payment via paypal. Can you email your paypal? Thank you -- 73 Barb WB2CBA

Okay, Mike. I already sold 4 kits and 6 kits are left for beta. After that, the price will be higher. Thanks, Adam

Adam, Thanks. I will have to wait for after the holidays but glad it will be available. Mike N2MS

Thank Adam ! Jim

Adam, I am not a technician but enjoy experimenting with circuits. I would check out the LED with your multimeter. Maybe it is defective. It sure looks like you did a great job in soldering. I am

Guys, I recorded the video for KT build but met an issue. The LED is not working. See this video: https://youtu.be/QjzgBxF_FHI?si=oBhNCcAkIz5uCDtY I fixed the issue later, but can you figure out what