开云体育

I have tried both PJ Talk and Crestron Connected and can not get control of this PJ.? Logged into the web interface and made sure the settings were correct.? Am I missing something?

Hey John,
I deal mostly with the VPL ES home cinema line, but knowing Sony the protocol may be the same...
Here's some details for a project I just did with a 715ES. If you need the module I can send it to you...

TCP Client Port: ? ? 53484d
Logic Module:? ? ? ?Sony VPL-VW1000ES IP v1.0

If using Crestron Connected, have you check the IPID is correct, sometimes in devices you have to enter it in decimal, while in the program it's hexadecimal.

Projector shows to use HEX, but the ID is 03 so it is right regardless. I've tried both putting the IP of the projector and using the loop back in the program and it just doesn't ever show online.? With PJ talk, I made sure it was enabled and verified that the port is default and also verified that it was correct for the TCP client.? The TCP client status is 2 and still no control.? On a thought, I checked for a Certified Driver and found one that was updated in 2023.? It uses the ADCP protocol and works well.

This chassis works with "room view connected display" with this model and the ipid is specified in decimal, 0a = 10, you also need to tell the projector via the remote where to get network from either LAN or via HDBASE-T should you be using a dmps for example.

You might also need a firmware update as we found an issue with filter cleaning getting the chassis stuck in an unrecoverable loop if you polled the off power sub 10seconds it would cancel the internal timer and have a fit but because it took longer for "is cooling" feedback caught us out. Otherwise projector is stable and performs well

I verified all of that RK.? Which is why I was at a loss. I tried RVCD, ensured that it was enable via the projector web page.? ID was set for 03 which should be the same in Dec or Hex pointed at my processor IP.? In my program, I tried using the IP of the projector as well as loop back.? Just no joy.? I appreciate the suggestions.? I ended up using the Certified module.

had to turn ON ADCP for the Certified module.? Certified module works well and does what I need.? I have a test program for the certified module that I will upload.