开云体育

I am a little confused on how to set this up in the program (SIMPL).? We have a DMPS3-300-C as the processor and switcher that we are going to use DM output 3 to connect to the Digital Link input on the projector.? Would anyone have some screenshots on how they may have set this up in the program?? From reading some of the post about this in the past I am still a little confused.? Do I need to use a HDBT receiver definition on the DM 3 output and then also a roomview connected display (or TCP/IP) on the ethernet devices (using something like IP-ID 05)?? Any help would be grateful as I rarely run into this type of situation.?

Rick Arnold

You're on the absolute right track.
Add the projector to your code as a roomview connected display as an ethernet device. Note that if you go above IP ID 09, you will have to convert to hex when entering the ID in the display.?
No need for an HDBT receiver on DM out 3. Just connect the output to the Digital Link Input on the projector.?
Also, when setting up the projector, you might need to go download the Crestron Roomview xPanel tool if your projector has a flash based web gui.?

Seems fairly simple? :)? ?all I would need to figure then would be the IP address of the projector for roomview connected display defination?

thanks for the help yesterday.? Turning the projector on and off and switching inputs seemed to work nicely.? Now they are asking if there is a way, I can put lamp hours on the touchpanel.? I put in tcp/ip connection, but it would keep connecting and disconnecting.? Seems like it would on stay connected for about 15-20 secs at a time.? After looking at the response I was getting once it was connected, I think maybe I need to put in username and password.? I was just curious if anyone has any luck controlling this projector via ethernet and how they would keep the connection open?? I was looking at maybe using the Panasonic PT-DZ12000 IP module from the app market.

Any thoughts or ideas would be greatly appreciated.

Rick

Maybe try the Crestron Connected Display symbol vs the Roomview Connected Display symbol. The Crestron Connected Display symbol includes lamp hour outputs.

thanks.? I will give that a try.? Would you happen to know off the top of your head if source 7 is still the HDMI input (as it is on the roomview connected display symbol)?

Hi Rick,
I am trying to do exactly the same operation my projector panasonic DZ870 has ip adress of 192.168.10.16 I added the roomview connected display on IPID 07 and I configure it to have the ip adress of the projector, unfortunatelly when I am triggering beamer ON the beamer do not react. I am connected the projector directly to the switch. I am using RMC4 as my control unit. Any ideas what I am doing wrong?