开云体育

Am looking for guidance regarding how to make USB routing work for NVX.?
These are 360/360c units, not using a Director.?

I can get FB from the control point (where the KB/Mouse live) and send that to the destination PC.?
However, the USB never connects. Set the transport type and the layer.?
Am told that there is some kind of negotiation or handshake with MAC addresses that needs to occur??
If so, it is not at all clear how one goes about doing that.?

Have spent most of a week trying to get this to work with no success.?

Appreciate any insight from the group since OLH or NVX product pages have no info on this at all.?

Thanks, - Tray

At the PC end, you have to use the UCB-C port out of the 360s. Check that since it is a common misstake.?

Thanks,?

Yes, that part of the cabling is good. Although the NVX port labeling isn't real clear.?
I should have been more specific in my request.?
Am seeking advice on the programming.?

Thought it was as simple as sending a MAC address from the keyboard/mouse control endpoint into one of the seven serial inputs on the USB subslot for the target PC NVX endpoint.?
Seems it may be a lot more complicated than that.?

Thanks again,?

Tray

Tray,

You have to send the MAC addresses both directions not just from the Remote to the Local.

So Take the Device ID from the Remote unit and feed it into the input of the Local Unit
Then also take the Device ID from the Local Unit and feed it into the Remote Unit.

If auto paring is enabled then populating those 2 strings is all you need to establish the route.

Also just verify that the units are actually in the proper Local and Remote modes by looking in the Web UI. ?If you have 2 units set to Remote or local they wont pair.

Thanks!

First thing, are both NVX on the same broadcast domain? If so, you send the ID (mac addr) of the USB Local to the USB Remote and vice versa; requires both ways. Also check you have USB Auto Pairing enabled on all NVX, just saves you the step of pulsing the USB Pair digital

I'm working through some of this right now.? If I use automatic pairing and just fire off MACs, do I have to unpair all devices on a given endpoint?? Or can I just send 00:00:00:00:00 where a device was paired?