开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. Crestron
  2. Topics

IV-SAM-VX2 selecting a camera to stream.

 

is there a way to make a IV-SAM-VX2 select a specific camera to stream? the "Camera_Select" only selects the camera to control, but doesn't change the camera that is to be streamed. "Manual_Switch_Camera" cycles through the cameras....I'm looking for way to select stream camera 1 or 2 or 3, etc...
 

Think you need to set up scenarios for that.? Kinda defeats the purpose of installing a very expensive auto camera switching system though! Lol
 

Couple Options.
? ?You can use "Scenarios" if you want to keep with the Ethernet device IV-SAM-VX2 definition.
?
Or you can use the "1Beyond Automate_VX_v1.1" module in the crestron database.
The "Manual Switch Camera" inside the "Camera Controls" section is an analog value that allows you to select which camera you want to switch to but you first have to turn Autoswitch off.
 

The "Manual Switch Camera" inside the "Camera Controls" section is an analog value that allows you to select which camera you want to switch to but you first have to turn Autoswitch off.

and in my recent experience, you then have to trigger the digital input to poll the state of the autoswitch. If you don't, an error message is sent that manual switching is not allowed while autoswitch is enabled. That is with a Scenario turning the auto-switch state to off.

On Tue, Feb 11, 2025 at 6:19?AM Chris via <cmeacham=[email protected]> wrote:
Couple Options.
? ?You can use "Scenarios" if you want to keep with the Ethernet device IV-SAM-VX2 definition.
?
Or you can use the "1Beyond Automate_VX_v1.1" module in the crestron database.
The "Manual Switch Camera" inside the "Camera Controls" section is an analog value that allows you to select which camera you want to switch to but you first have to turn Autoswitch off.
 

In the hardware definition for VX2, you populate the Analog for "Camera_Select" and then trigger the digital "Manual_Switch_Camera" and it will change the shot that is outputting from the VX2. If you are in the fullscreen layout this will switch between the cameras fullscreen.? As previously mentioned, you must have Autoswitch disabled and Output must be enabled.

1 - 5 of 5