¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Crestron
  2. Topics

Help - S+ Module issue

 

So recently I have had an issue where older Modules with S+ embedded inside of them stop working after compiling.? Happen again today.? Have a project with a DBX Zone Pro 1261 in it.? Last time the system was compiled was July 27, 2019.? I imported the archive did a save as and made changes.? Compile and Upload and the modules are broken.? Reload exist lpz and everything is fine.? Recompile original program and they break again.? Any Ideas?

Simpl? 4.11.06.1
CDB? ? 90.00.004.00
DDB? ? 115.08.002.00
 

Make sure the processor is running at least firmware version 1.601.0050.

--- Tuesday, November 3, 2020 at 6:35 PM, John Gabler wrote:

So recently I have had an issue where older Modules with S+ embedded inside of
them stop working after compiling. Happen again today. Have a project with a
DBX Zone Pro 1261 in it. Last time the system was compiled was July 27,
2019. I imported the archive did a save as and made changes. Compile and
Upload and the modules are broken. Reload exist lpz and everything is
fine. Recompile original program and they break again. Any Ideas?

Simpl 4.11.06.1
CDB 90.00.004.00
DDB 115.08.002.00
 

Try toggling series 2/3 off then on and recompile (inside S+).
Or dedete the SPI works folder.?
 

Can't do much about the firmware.? It's an MC3 run 1.501 and 502 is latest.? I'll have to see what firmware of my other project that I saw this issue with the Integra volume control S+.
 

Did try to recompile the s+ module.? But I didn't toggle the 3 series button.? I'll give it a shot.
 

deleting the SPI folder did it.? Thanks

1 - 6 of 6