Was called into a Library to fix a room system that was installed by others a few years ago. All of the 5 rooms have Sharp EQ1 series display (TH-65EQ1U) with 4 working fine. All were setup using Crestron Connect and the Crestron RoomView Connected Display module. It looked like the room may have never been setup - the DM Receiver had the HDMI cable coming out of the Input side going to the display and the I address of the unit was set to a static IP address, but was not on the proper LAN segment. Corrected those issues but no control from the MPC3-201. Since the IP table shows that the display off line - I assume that the displays Crestron Connect web page is not properly configured. Crestron Connect is On in the display menu and I have tried every user ID / password combination that I could find on-line to access the web server of the display, but have been unable to access it? Any thought? Thanks!

IPID is set correctly on the display for RoomView Connected control? With the IPID converted to decimal instead of hex?
--
Josh Winn
The LiquidPixel Group

开云体育

Issue is I can not access the Sharps web server to confirm any of the parameters? None of the ID/Passwords in the docs / Internet have not worked?

A factory reset of the monitor to set its credentials to default? Then you will be able to access its web interface.

Have not found any way to perform a hard factory reset for the Sharp EQ1 series displays. From all of my readings - I may be able to reset the password for the web browser by resetting the Network defaults within the Menu. While not 100% sure - then the user ID/ password for admin rights would be: dispadmin / @Panasonic ?