¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Crestron
  2. Topics

BSS BLU Matrix Router

 

I am using the BSS BLU modules v1.4

I have a Matrix Router to control. This matrix router has two inputs to a single output.

I have the Control Type as SourceMatrix. The [A] parameter is set to 1 as it is a single output.

For the InputValue analog, I can send 1d or 2d to switch between either input. The control itself allows for either input or both inputs to be active.

What do I do if I need both to be active?
I assume I can set the inputValue to 1 and then pulse the Route input, set the InputValue to 2 and then pulse Route again.

What will the ActualRoute output reflect when both are routed?

OR do I need to use two instances of the module, where I have one of them set to input 1 and the other to input 2 and then look at each separately?
 

A router only allows a single input routed to an output at a time. It seems you¡¯re looking for some version of a mixer. Matrix maybe?
 
Edited

I see that it is in the State Control module and not in the Router module,
 

Does anyone know if the router control will take an InputValue of 0d to force an unroute if the Route input is held high?

Or do you need to feed it the same InputValue as the ActualRoute value and then pulse Deroute?

On Mon, Feb 13, 2023 at 2:10 PM BruteForceIsUnderRated via <crestronpro=[email protected]> wrote:

[Edited Message Follows]

I see that it is in the State Control module and not in the Router module,
 

You should be able to assign a zero value and route,

1 - 5 of 5