开云体育

Has anyone been able to create a successful link from a Biamp X400 to the Crestron NAX Amplifier.? ?I have setup the Biamp to be in AES67 mode.? I can route any NVX-E20 or E30 to the Biamp with no issues.? I just cannot get the mix output of the Biamp to go into the amp.? ?I never see the Crestron Amp on the Dante controller, but I was able to search using the NAX amp and see the Biamp AES67 stream, but it will not join.? ?Just keeps showing connecting.....? ?It seems like there is some incompatibility setting that I am missing either on Biamp or the Crestron unit...??

When I try to switch the NAX amp over to Dante mode, it loses the Commissioning page and so there is no way to setup the multicast address.

I haven't used them with the X400, but I have used them with Q-SYS a couple times. Are you trying to set this up with AES67 or Dante. The behavior of the commissioning page going away is expected, Dante is going to be unicast in most applications and Dante controller will handle the routing. If you are trying to use AES67, you just need to put the multicast stream IP (generated from the X400 AES67 output stream) in the AES67 receiver section of NAX. You shouldn't need to work with the commissioning tab I believe this is only used to set the multicast addresses of the internal streams for transmitting.?

?

I dont think attachments are allowed in threads, but feel free to email me and I can send you some screenshots of the setup in NAX on a working setup.?

Well, finally figured it out...? ?Crestron NVX units will not accept single channel AES67 audio.? ? It turns out that you can only send two channel audio from anything else to the NVX units..? I combined a couple of my microphone channel streams and boom, it started working.? For anyone else that is trying to send AES67 from Biamp to Crestron, you must make all your outputs dual channel if you want to send it to any NVX units...? I was able to get the stream to start going to an NVX-360, but the audio was really distorted.? The DM-NAX-AMP-X300 would not even start the stream.? I rebuilt the Tesira file with all outputs being dual channel and we are good...? ?I heard this is the same if you are trying to send audio from a Yamaha to NVX as well.. Thanks for you help...