开云体育

Cut Function Programing

[email protected] All Messages By This Member #235799 How to program “Cut” function that forces the lights to the target level immediately if the button is pressed a second time.?
Brendon P All Messages By This Member #235801 This is a question that gets asked quite a bit, as it’s a requirement for the 201 exam. All I can tell you is read the help files. F1 is your best friend.
Lincoln King-Cliby All Messages By This Member #235802 开云体育 Didn’t realize it was on one of the current exams so I wont provide a specific answer but to add on to Brendon’s answer … it will be way simpler than you might think if you’re using the right symbol… ? -- Lincoln King-Cliby, CTS, DMC-E-4K/T/D Commercial Market Director Sr. Systems Architect \| Crestron Certified Master Programmer (Diamond) ControlWorks Consulting, LLC Direct: (+1)440.771.4807 \| Cleveland: (+1)440.449.1100? \| Boston: (+1)508.695.0188 \| DC: (+1)202.381.9070? \| Fax: (+1)440.449.1106 Crestron Services Provider \| Biamp Authorized Independent Programmers \| Extron Qualified Independent Programmer ? toggle quoted message Show quoted text From: [email protected] <[email protected]> On Behalf Of Brendon Packwood Sent: Saturday, June 20, 2020 9:49 AM To: [email protected] Subject: Re: [crestron] Cut Function Programing ? This is a question that gets asked quite a bit, as it’s a requirement for the 201 exam. All I can tell you is read the help files. F1 is your best friend.
Eric Low All Messages By This Member #235809 开云体育 Yes it was one of the exam requirement from CTI-201 entrance exam. Yup like Lincoln said you just need to find the right symbol for the right job. If you have taken 101 they would have shown you what to use already. Best Regards Eric Low toggle quoted message Show quoted text On 20 Jun 2020, at 10:15 PM, Lincoln King-Cliby <lincoln@...> wrote: ? Didn’t realize it was on one of the current exams so I wont provide a specific answer but to add on to Brendon’s answer … it will be way simpler than you might think if you’re using the right symbol… ? -- Lincoln King-Cliby, CTS, DMC-E-4K/T/D Commercial Market Director Sr. Systems Architect \| Crestron Certified Master Programmer (Diamond) ControlWorks Consulting, LLC Direct: (+1)440.771.4807 \| Cleveland: (+1)440.449.1100? \| Boston: (+1)508.695.0188 \| DC: (+1)202.381.9070? \| Fax: (+1)440.449.1106 Crestron Services Provider \| Biamp Authorized Independent Programmers \| Extron Qualified Independent Programmer ? From: [email protected] <[email protected]> On Behalf Of Brendon Packwood Sent: Saturday, June 20, 2020 9:49 AM To: [email protected] Subject: Re: [crestron] Cut Function Programing ? This is a question that gets asked quite a bit, as it’s a requirement for the 201 exam. All I can tell you is read the help files. F1 is your best friend.

Previous Topic Next Topic