开云体育

X panel and CP3 problems

Jon Read #195828 开云体育 Hi Guys ? Anybody had any problems with the standard executable X panel and a CP3, CP3 is running 1.009 and VTools is the latest 5.5.08, Comes up with the usual “Control System Connection:Disconnected” Have checked and double checked that I have the correct addresses and IP ID’s etc, tried initializing processor, but still no go. It’s not my PC as I can run another X panel on a different processor OK. ? Cheers Jon ? ?
[email protected] #195837 Hmmm, I have not had any issues with Xpanel.? I typically hard code the IP Address in VTpro, have you tried this or are you simply opening Xpanel and setting IP in settings?
Jono Paul #195843 开云体育 I have not had a problem like that before either.? But I have tried this where you hardcode the IP address and ID into the VTPro project, but then when you open the Xpanel I have to enter all the host settings again.? Would be great if I the client didn't have to do this.? Any ideas?? Thanks Jono toggle quoted message Show quoted text On 25 Jun 2014, at 3:32 PM, "sbob1123@... [Crestron]" <Crestron@...> wrote: ? Hmmm, I have not had any issues with Xpanel.? I typically hard code the IP Address in VTpro, have you tried this or are you simply opening Xpanel and setting IP in settings?

Previous Topic Next Topic